During the production of deep oil and gas, scaling, waxing, hydrate ice plugging and other problems easily occur. To solve these problems, reducing the temperature loss of oil pipelines is a feasible method. In order to protect the outer wall coating from being damaged and losing its thermal insulation performance, this paper proposes a developed technology for a novel inner wall coating-insulated oil pipeline. A new temperature-resistant and heat-insulating material aerogel was optimized and developed, and it has an extremely low thermal conductivity of less than 0.055 W/m·K. The influence of different coating processes on the thermal insulation coefficient was analyzed, and a novel inner wall coating-insulated oil pipeline was developed. A testing and evaluation platform for its thermal insulation effect was built, and a finite element model was established to analyze the temperature field distribution. When the thickness of the inner coating was 0.5 mm, the thermal insulation effect of the new oil pipeline improved by about 29%. This technology could be widely used in the production of deep oil and gas, high salinity oil and water reservoirs, thin oil reservoirs, etc., to alleviate scaling and waxing phenomena.
5 June 2020 in Journal of Failure Analysis and Prevention
The Lower Permian M Formation marine carbonate gas reservoir in Block X of the Sichuan Chongqing exploration area has extreme working conditions with moderate H2S content (0.57%–0.97%), moderate CO2 content (2.59%–5.59%), and high formation pressure (70–80 MPa). Gas wells face challenges such as multi medium synergistic corrosion, large productivity differences, and limited economic viability. This article addresses the above issues for the first time by analyzing the dual corrosion mechanism, selecting corrosion-resistant pipes (nickel-based alloys/nickel–tungsten alloy coatings), evaluating the adaptability of corrosion inhibitor processes, and real-time monitoring and warning of corrosion risks. A collaborative anti-corrosion technology system of “mechanism material process monitoring” is constructed, and the first successful field implementation was carried out in this block. The experiment shows that the uniform corrosion rate of nickel–tungsten alloy coating under extreme working conditions (122 °C/85 MPa) is only 0.004 mm/a, which is more economical than traditional nickel-based alloys (cost reduction of 69%); CT2 series corrosion inhibitors can selectively inhibit the corrosion rate of gas wells with different water contents (efficiency > 82%). The combination of electromagnetic flaw detection and multi arm wellbore logging technology has achieved dynamic monitoring of downhole pipe corrosion. This system has been successfully applied in seven gas wells in Block X, achieving controllable corrosion risks, cost reduction and efficiency improvement, and providing a replicable technical paradigm for the safe and economic development of marine high-sulfur gas reservoirs.