The Seulawah Agam volcano, located in Aceh, hosts one of Indonesia’s largest unexploited geothermal resources that is included in the Indonesian Green Energy Program. Previous studies of the Seulawah geothermal system (SGS) have used partial data and methods without developing a comprehensive conceptual model of the reservoir and its fluid flow and heat transfer patterns. This study aims to characterize the groundwater flow and heat transfer patterns of the SGS through numerical modeling based on integrated geological, geophysical, and geochemical data. Numerical modeling was conducted along two representative transects: Ie Seum, Ie Jue, and Kawah van Heutsz manifestations. MODFLOW 6 was used to model groundwater flow and heat transfer using a new conceptual model derived from magnetotelluric data, chemical composition and physical properties of the fluid, isotopic data, and mineragraphic data. The low resistivity anomalies are closely related to fluid discharges beneath the Ie Seum and Ie Jue areas. The depth of the Ie Seum reservoir is around 1.0–2.5 km, with estimated temperatures of 120–242 °C, while the depth of the Ie Jue and Kawah van Heutsz reservoirs is between 0.8 and 2.5 km, with estimated temperatures of 150–316 °C. The modeling suggests that the Ie Seum and the Ie Jue–Kawah van Heutsz systems represent regional groundwater and intermediate-local flow regimes, respectively. It is suggested that drilling be conducted around the local Ie Jue hydrothermal system, which is more economical given the shallower reservoir and higher temperature.
31 October 2019 in Journal of Engineering and Technological Sciences
To improve the theory of Richard's equation, studying infiltration under free-draining conditions at the ground surface is necessary. Verification is required to clarify the physical model of water movement. The aim of this study was to describe multistage measurements of both the wetting and the drying front scheme of one-dimensional infiltration at laboratory scale. A soil-column infiltration apparatus was built consisting of a double acrylic wall, a sensor set and a light bulb. Acrylic was chosen as the material for the wall to minimize possible heat conduction on the wall side, which was wrapped in double insulation to achieve adiabatic condition. The following three main sensors were used and controlled by a microcontroller: water-content, pressure and temperature sensors. Meanwhile, the light bulb at the top of the apparatus was set to non-isothermal condition. The instrument was successfully built to describe vertical water movement. Slight modifications were carried out to ensure more precise observation. This resulted in the initiating of new shape interpretation based on the water-ponding measurement to refine the simplified pattern that was introduced by the conventional Green-Ampt theory.