Copper oxide nanoparticles (CuONPs) have received considerable attention because of their wide range of applications, particularly in the development of antimicrobial materials for medical, environmental, and industrial purposes. However, conventional synthesis routes often involve the use of toxic chemicals and environmentally harmful conditions. To overcome these limitations, green synthesis strategies have been developed as sustainable alternatives through the use of natural reducing and stabilizing agents. In this study, Citrus sinensis leaf extract, which exhibits high antioxidant capacity, was investigated for green synthesis of CuONPs, followed by their subsequent incorporation into a chitosan polymeric matrix. The optimal synthesis conditions were achieved at a pH of 7.0 using copper(II) acetate monohydrate (Cu(CH3COO)2·H2O) at a concentration of 10.0 g L−1 and a calcination temperature of 300 °C. The resulting CuONPs exhibited a heterogeneous morphology, with average particle sizes ranging from 20 to 30 nm, and demonstrated satisfactory antimicrobial activity against Escherichia coli and Staphylococcus aureus. The incorporation of these NPs into chitosan yielded composite materials with enhanced antimicrobial performance, highlighting the added value of polymer–NP hybrid systems. Although these composite materials were not evaluated under realistic operational conditions, the optimized green protocol provides a robust methodological basis for future studies targeting water disinfection and other environmentally relevant technologies.
Carbon black (CB) is the primary reinforcing filler in tire tread elastomers; however, high filler loadings increase hysteresis and accelerate aging. In this context, hybrid reinforcement strategies incorporating graphene oxide (GO) have attracted considerable attention due to the unique mechanical and thermal properties of this nanomaterial. This study evaluates a laboratory-scale, industrially compatible approach for GO incorporation through conventional two-roll-mill mixing, using processing oil as the dispersion medium. Elastomeric formulations with GO loadings of 0.5–1.25 parts per hundred rubber (phr) were prepared and evaluated for rheological, mechanical, dynamic mechanical, morphological, and thermal conductivity properties. Overall, GO incorporation did not significantly alter the cure characteristics or conventional mechanical properties of the compounds. Nevertheless, NR/CB/GO_0.75 showed the highest retention of tensile strength after thermo-oxidative aging and a 10.6% increase in thermal conductivity, whereas NR/CB/GO_1.25 exhibited a favorable tan δ profile. The latter formulation showed higher tan δ at low temperature and lower values at elevated temperatures, suggesting potential improvements in wet-grip-related response and reduced hysteretic losses, respectively. Although the oil-assisted incorporation route did not produce substantial mechanical reinforcement under the investigated conditions, it showed potential for selectively modifying dynamic behavior, thermal transport, and the retention of mechanical properties after aging using conventional rubber-processing equipment. Further optimization of GO purity, dispersion stability, and filler-matrix compatibility is required before the practical and economic feasibility of this approach can be established.