The rainfall-runoff process (RRP) is an important part of hydrologic process. There is an effective measure to study RRP through artificial rainfall simulation. This paper describes a study on three growing stages (jointing stage, tasseling stage, and mature stage) of spring maize in which simulated rainfall events were used to study the effects of various factors (rainfall intensity and slope gradient) on the RRP. The RRP was tested with three different rainfall intensities (0.67, 1.00, and 1.67 mm/min) and subjected to three different slopes (5°, 15°, and 20°) so as to study RRP characteristics in semiarid regions. Regression analysis was used to study the results of this test. The following key results were obtained: (1) With the increase in rainfall intensity and slope, the increasing relationship with rainfall duration, overland flow, and cumulative runoff, respectively, complied with logarithmic and quadratic functions before reaching stable runoff in each growing stage of spring maize; (2) The runoff coefficient increased with the increase in rainfall intensity and slope in each growing stages of spring maize. The relationship between runoff coefficient, slope, rainfall intensity, rainfall duration, antecedent soil moisture, and vegetation coverage was multivariate and nonlinear; (3) The runoff lag time decreased with the increase in rainfall intensity and slope within the same growing stage. In addition, the relationship between runoff lag time, slope, rainfall intensity, antecedent soil moisture, and vegetation coverage could also be expressed by a multivariate nonlinear equation; (4) The descent rate of soil infiltration rate curve increased with the increased rainfall intensity and slope in the same growing stage. Furthermore, by comparing the Kostiakov, Horton, and Philip models, it was found that the Horton infiltration model was the best for estimating soil infiltration rate and cumulative infiltration under the condition of test.

Mesoscale numerical weather prediction (NWP) models are gaining more attention in providing high-resolution rainfall forecasts at the catchment scale for real-time flood forecasting. The model accuracy is however negatively affected by the "spin-up" effect and errors in the initial and lateral boundary conditions. Synoptic studies in the meteorological area have shown that the assimilation of operational observations, especially the weather radar data, can improve the reliability of the rainfall forecasts from the NWP models. This study aims at investigating the potential of radar data assimilation in improving the NWP rainfall forecasts that have direct benefits for hydrological applications. The Weather Research and Forecasting (WRF) model is adopted to generate 10 km rainfall forecasts for a 24 h storm event in the Brue catchment (135.2 km²) located in southwest England. Radar reflectivity from the lowest scan elevation of a C-band weather radar is assimilated by using the three-dimensional variational (3D-Var) data-assimilation technique. Considering the unsatisfactory quality of radar data compared to the rain gauge observations, the radar data are assimilated in both the original form and an improved form based on a real-time correction ratio developed according to the rain gauge observations. Traditional meteorological observations including the surface and upper-air measurements of pressure, temperature, humidity and wind speed are also assimilated as a bench mark to better evaluate and test the potential of radar data assimilation. Four modes of data assimilation are thus carried out on different types/combinations of observations: (1) traditional meteorological data; (2) radar reflectivity; (3) corrected radar reflectivity; (4) a combination of the original reflectivity and meteorological data; and (5) a combination of the corrected reflectivity and meteorological data. The WRF rainfall forecasts before and after different modes of data assimilation are evaluated by examining the rainfall temporal variations and total amounts which have direct impacts on rainfall–runoff transformation in hydrological applications. It is found that by solely assimilating radar data, the improvement of rainfall forecasts are not as obvious as assimilating meteorological data; whereas the positive effect of radar data can be seen when combined with the traditional meteorological data, which leads to the best rainfall forecasts among the five modes. To further improve the effect of radar data assimilation, limitations of the radar correction ratio developed in this study are discussed and suggestions are made on more efficient utilisation of radar data in NWP data assimilation.

To identify whether the spatial and temporal distribution of temperature extremes and precipitation extremes has changed in central and eastern China including Henan, Shandong, Anhui and Jiangsu provinces, the spatial and temporal distributions of extreme temperature and precipitation indices trends during 1961–2011 were investigated and analysed. To guarantee the accuracy of trend analysis, daily maximum and minimum surface temperature and daily precipitation from 299 meteorological stations were used. Eight extreme temperature indices and seven extreme precipitation indices were chosen. Mann–Kendall method was used to check the statistical significance of trends, while Sen's nonparametric method was used to calculate the trend magnitudes. The analyses of extreme temperature indices detected significant and stable trends in the majority of the stations, especially for the most part of southern Anhui and southern Jiangsu provinces. The strongly stable downward trends in cold extremes and the strongly stable upward trends in hot extremes were recorded in most of the regions. In contrast, significant and stable positive trends were insignificantly recorded for precipitation extremes in the study area, which predominantly occurred in the southern part of the region. Furthermore, the positive trends were more frequent than the negative trends in most extreme precipitation indices. The results may provide a reference for a more particular knowledge of the climate change in this region and provide guidance for agriculture development.

The Weather Research and Forecasting (WRF) model is used in this study to simulate six storm events in two semi-humid catchments of northern China. The six storm events are classified into four types based on the rainfall evenness in the spatial and temporal dimensions. Two microphysics, two planetary boundary layers (PBL) and three cumulus parameterizations are combined to develop an ensemble containing 16 members for rainfall generation. The WRF model performs the best for type 1 events with relatively even distributions of rainfall in both space and time. The average relative error (ARE) for the cumulative rainfall amount is 15.82 %. For the spatial rainfall simulation, the lowest root mean square error (RMSE) is found with event II (0.4007), which has the most even spatial distribution, and for the temporal simulation the lowest RMSE is found with event I (1.0218), which has the most even temporal distribution. The most difficult to reproduce are found to be the very convective storms with uneven spatiotemporal distributions (type 4 event), and the average relative error for the cumulative rainfall amounts is up to 66.37 %. The RMSE results of event III, with the most uneven spatial and temporal distribution, are 0.9688 for the spatial simulation and 2.5327 for the temporal simulation, which are much higher than the other storms. The general performance of the current WRF physical parameterizations is discussed. The Betts–Miller–Janjic (BMJ) scheme is found to be unsuitable for rainfall simulation in the study sites. For type 1, 2 and 4 storms, member 4 performs the best. For type 3 storms, members 5 and 7 are the better choice. More guidance is provided for choosing among the physical parameterizations for accurate rainfall simulations of different storm types in the study area.