Despite the potential of biogas from waste/wastewater treatment as a renewable energy source, the presence of pollutants and the rapid decrease in the levelized cost of solar and wind power constrain the use of biogas for energy generation. Biogas conversion into ectoine, one of the most valuable bioproducts (1000 €/kg), constitutes a new strategy to promote a competitive biogas market. The potential for a stand-alone 20 L bubble column bioreactor operating at 6% NaCl and two 10 L interconnected bioreactors (at 0 and 6% NaCl, respectively) for ectoine production from biogas was comparatively assessed. The stand-alone reactor supported the best process performance due to its highest robustness and efficiency for ectoine accumulation (20-52 mgectoine/gVSS) and CH4 degradation (up to 84%). The increase in N availability and internal gas recirculation did not enhance ectoine synthesis. However, a 2-fold increase in the internal gas recirculation resulted in an approximately 1.3-fold increase in CH4 removal efficiency. Finally, the recovery of ectoine through bacterial bio-milking resulted in efficiencies of >70% without any negative impact of methanotrophic cell recycling to the bioreactors on CH4 biodegradation or ectoine synthesis.
14 July 2024 in Journal of Environmental Management
Nowadays, the utilization of biogas for energy generation is hindered by the declining production costs of solar and wind power. A shift towards the valorization of biogas into ectoine, a highly valuable bioproduct priced at 1000 €⸱kg-1, offers a novel approach to fostering a more competitive biogas market while contributing to carbon neutrality. This study evaluated the optimization of CH4 gas-liquid mass transfer in 10 L bubble column bioreactors for CH4 conversion into ectoine and hydroxyectoine using a mixed methanotrophic culture. The influence of the empty bed residence time (EBRTs of 27, 54, and 104 min) at different membrane diffuser pore sizes (0.3 and 0.6 mm) was investigated. Despite achieving CH4 elimination capacities (CH4-ECs) of 10-12 g⸱m-3⸱h-1, an EBRT of 104 min mediated CH4 limitation within the cultivation broth, resulting in a negligible biomass growth. Reducing the EBRT to 54 min entailed CH4-ECs of 21-24 g⸱m-3⸱h-1, concomitant to a significant increase in biomass growth (up to 0.17 g⸱L⸱d-1) and reaching maximum ectoine and hydroxyectoine accumulation of 79 and 13 mg⸱gVSS-1, respectively. Conversely, process operation at an EBRT of 27 min lead to microbial inhibition, resulting in a reduced biomass growth of 0.09 g⸱L⸱d-1 and an ectoine content of 47 mg⸱gVSS-1. While the influence of diffuser pore size was less pronounced compared to EBRT, the optimal process performance was observed with a diffuser pore size of 0.6 mm.
Biogas is a key renewable energy vector that can support the transition toward a net-zero carbon economy. Its direct use as a natural gas substitute is limited because it must be upgraded to meet CH4 purity specifications required for injection into the gas grid or for use as a vehicle fuel. This review summarizes current progress in photosynthetic biogas upgrading, an emerging biotechnology based on the symbiotic action of microalgal–bacterial consortia capable of supporting gas purification with nutrient recovery in a single integrated process. This biotechnology relies on two stages: an absorption unit that enables gas–liquid mass transfer of the biogas pollutants, and a photobioreactor in which CO2 and other contaminants are removed. Optimal system performance is strongly influenced by the liquid to gas (L/G) ratio, with values between 0.5 and 1.0, typically balancing effective CO2 removal and limited CH4 dilution. High-alkalinity nutrient media (1.5–2.5 gIC L−1) and pH > 9 remain essential to sustain the chemical gradients driving CO2 mass transfer. Robust microalgae/cyanobacteria such as Chlorella vulgaris and Pseudanabaena sp. frequently dominate these systems. Recent efforts in the biostimulation of photosynthesis are presented based on their potential to enhance biomass productivity and CO2 removal, which could decrease the footprint of the process and facilitate its large-scale adoption for biomethane production.