Recent decades have witnessed much interest in the application of active and semi-active control strategies for seismic protection of civil infrastructures. However, the reliability of these systems is still in doubt as there remains the possibility of malfunctioning of their critical components (i.e. actuators and sensors) during an earthquake. This paper focuses on the application of the sliding mode method due to the inherent robustness of its fault detection observer and fault-tolerant control. The robust sliding mode observer estimates the state of the system and reconstructs the actuators’ faults which are used for calculating a fault distribution matrix. Then the fault-tolerant sliding mode controller reconfigures itself by the fault distribution matrix and accommodates the fault effect on the system. Numerical simulation of a three-story structure with magneto-rheological dampers demonstrates the effectiveness of the proposed fault-tolerant control system. It was shown that the fault-tolerant control system maintains the performance of the structure at an acceptable level in the post-fault case.
21 December 2021 in Computer-Aided Civil and Infrastructure Engineering
The use of seismic control systems in building structures requires simultaneous attention to uncertainties in model parameters, measurement noises, faults on sensors and dampers, and earthquake input. The present study suggests a procedure to resolve the complications of these issues in semi-active control of building structures. To this end, the effects of faults on sensors and dampers are decoupled by using transfer matrices. The sensor fault and the structure's state are estimated by a dynamic neural network (DNN)-based observer. Later, parametric uncertainty in the structure's model and fault on dampers are atoned by an adaptive controller that guarantees the stability of the system during an earthquake. In this controller, DNN is used to concurrently identify and compensate dampers' faults. The effectiveness of the proposed method was confirmed by numerical simulation of a three-story structure with magneto-rheological dampers.
10 October 2011 in Structural Control and Health Monitoring