Air filtration has seen a sizable increase in the global market this past year due to the COVID-19 pandemic. Nanofiber nonwoven mats are able to reach certain efficiencies with a low-pressure drop, have a very high surface area to volume ratio, filter out submicron particulates, and can customize the fiber material to better suit its purpose. Although electrospinning nonwoven mats have been very well studied and documented there are not many papers that combine them. This review touches on the various ways to manufacture nonwoven mats for use as an air filter, with an emphasis on electrospinning, the mechanisms by which the fibrous nonwoven air filter stops particles passing through, and ways that the nonwoven mats can be altered by morphology, structure, and material parameters. Metallic, ceramic, and organic nanoparticle coatings, as well as electrospinning solutions with these same materials and their properties and effects of air filtration, are explored.

The purpose of this study was to investigate the relationships between a type of engineering material and the ice adhesion strength while in direct application in icing conditions. Ice adhesion tests were conducted on various materials with different surface conditions. There is an identified need for systematic studies on the effects of varying surface conditions with well-characterized roughness and accurate adhesion measurement. This information is key in understanding the adhering behaviour of ice which is a necessary prerequisite for modelling the behaviour of ice adhesion to other surfaces and for icing prevention. Results show that the type of material will determine, in large, the strength of the ice adhesion between surfaces with similar roughness characteristics and the receding contact angle of water can be used as a predictor of relative ice adhesion. The adhesive strength of ice can be increased or decreased dramatically by means of adjusting the surface roughness with a uniform process. Each material tested exhibits a similar linear relationship. There was a stark contrast in the ice adhesion between the varying materials despite very similar polished surface conditions and static water contact angles. Ice bonded to the glass surface with an adhesion of 1562 ± 113 kPa, and to aluminum at 1039 ± 117 kPa, and stainless steel at 1022 ± 115 kPa, and finally Teflon at only 33 ± 52 kPa and during 80% of trials the ice/substrate interface was broken with no measured adhesion. The information gathered can be used to improve designs for a number of devices needed in cold weather climates.

An experimental investigation was performed to study the effect of surface roughness and oxidation on the shear strength of single-lap-joints of AA6061, AA7075 aluminum alloys and an AISI 1080 steel alloy bonded with two different epoxy adhesives. An optimum surface roughness that provided the maximum shear strength was obtained for all the alloys at room temperature. The variation of the shear stress due to the different heat treatment temperatures revealed that the oxides developed on the alloy surfaces adversely affected the adhesive shear strength. The bulk concentration of magnesium of the aluminum alloys were also observed to affect the adhesive shear strength of the joints.