We investigate a large geodetic data set of interferometric synthetic aperture radar (InSAR) and GPS measurements to determine the source parameters for the three main shocks of the 2016 Central Italy earthquake sequence on 24 August and 26 and 30 October (Mw 6.1, 5.9, and 6.5, respectively). Our preferred model is consistent with the activation of four main coseismic asperities belonging to the SW dipping normal fault system associated with the Mount Gorzano‐Mount Vettore‐Mount Bove alignment. Additional slip, equivalent to a Mw ~ 6.1–6.2 earthquake, on a secondary (1) NE dipping antithetic fault and/or (2) on a WNW dipping low‐angle fault in the hanging wall of the main system is required to better reproduce the complex deformation pattern associated with the greatest seismic event (the Mw 6.5 earthquake). The recognition of ancillary faults involved in the sequence suggests a complex interaction in the activated crustal volume between the main normal faults and the secondary structures and a partitioning of strain release.
We investigate the 19 September 2021 eruption of the Cumbre Vieja volcano (La Palma, Canary Islands, Spain). In particular, we analyze the Differential Interferometric Synthetic Aperture Radar (DInSAR) measurements obtained by processing Sentinel‐1 images acquired from both ascending and descending orbits. First, we show the importance, for oceanic islands like La Palma, of investigating DInSAR products retrieved from time series, instead of single interferograms, to effectively remove possible atmospheric artifacts within the displacement measurements. Subsequently, we invert the retrieved data through analytical modeling. Our results highlight that a sill–like source was active in the pre–eruptive phase (8–16 September), whereas the action of two dikes prevailed during the co‐eruptive phase (17–22 September). This evolution suggests a process of magma rising through a network of interconnected sills and dikes. The seismicity, that preceded and accompanied the onset of the eruption, is consistent with our findings.
We investigate the Mw 6.5 Norcia (Central Italy) earthquake by exploiting seismological data, DInSAR measurements, and a numerical modelling approach. In particular, we first retrieve the vertical component (uplift and subsidence) of the displacements affecting the hangingwall and the footwall blocks of the seismogenic faults identified, at depth, through the hypocenters distribution analysis. To do this, we combine the DInSAR measurements obtained from coseismic SAR data pairs collected by the ALOS-2 sensor from ascending and descending orbits. The achieved vertical deformation map displays three main deformation patterns: (i) a major subsidence that reaches the maximum value of about 98 cm near the epicentral zones nearby the town of Norcia; (ii) two smaller uplift lobes that affect both the hangingwall (reaching maximum values of about 14 cm) and the footwall blocks (reaching maximum values of about 10 cm). Starting from this evidence, we compute the rock volumes affected by uplift and subsidence phenomena, highlighting that those involved by the retrieved subsidence are characterized by significantly higher deformation values than those affected by uplift (about 14 times). In order to provide a possible interpretation of this volumetric asymmetry, we extend our analysis by applying a 2D numerical modelling approach based on the finite element method, implemented in a structural-mechanic framework, and exploiting the available geological and seismological data, and the ground deformation measurements retrieved from the multi-orbit ALOS-2 DInSAR analysis. In this case, we consider two different scenarios: the first one based on a single SW-dipping fault, the latter on a main SW-dipping fault and an antithetic zone. In this context, the model characterized by the occurrence of an antithetic zone presents the retrieved best fit coseismic surface deformation pattern. This result allows us to interpret the subsidence and uplift phenomena caused by the Mw 6.5 Norcia earthquake as the result of the gravitational sliding of the hangingwall along the main fault plane and the frictional force acting in the opposite direction, consistently with the double couple fault plane mechanism.
In this work, we investigate the Mw 5.9 earthquake occurred on 7 November 2019 in the East-Azerbaijan region, in northwestern Iran, which is inserted in the tectonic framework of the East-Azerbaijan Plateau, a complex mountain belt that contains internal major fold-and-thrust belts. We first analyze the Differential Synthetic Aperture Radar Interferometry (DInSAR) measurements obtained by processing the data collected by the Sentinel-1 constellation along ascending and descending orbits; then, we invert the achieved results through analytical modelling, in order to better constrain the geometry and characteristics of the seismogenic source. The retrieved fault model shows a rather shallow seismic structure, with a center depth at about 3 km, approximately NE–SW-striking and southeast-dipping, characterized by a left-lateral strike-slip fault mechanism (strike = 29.17°, dip = 79.29°, rake = −4.94°) and by a maximum slip of 0.80 m. By comparing the inferred fault with the already published geological structures, the retrieved solution reveals a minor fault not reported in the geological maps available in the open literature, whose kinematics is compatible with that of the surrounding structures, with the local and regional stress states and with the performed field observations. Moreover, by taking into account the surrounding geological structures reported in literature, we also use the retrieved fault model to calculate the Coulomb Failure Function at the nearby receiver faults. We show that this event may have encouraged, with a positive loading, the activation of the considered receiver faults. This is also confirmed by the distribution of the aftershocks that occurred near the considered surrounding structures. The analysis of the seismic events nucleated along the left-lateral strike-slip minor faults of the East-Azerbaijan Plateau, such as the one analyzed in this work, is essential to improve our knowledge on the seismic hazard estimation in northwestern Iran.
On 7 November 2019 (22:47 UTC) a Mw 5.9 earthquake struck the East-Azerbaijan region, in the north-western Iran, about 100 km east of Tabriz, the fourth largest city of Iran with a population of over two million. This seismic event caused both widespread damage to the surrounding villages and casualties, killing about 5 people and injuring hundreds. The occurrence of this earthquake is related to the main geodynamic regime controlled by the oblique Arabia-Eurasia convergence and, in particular, this event is inserted in the tectonic context of the East-Azerbaijan Plateau, a complex mountain belt that contains internal major fold-and-thrust belts.In this work, we first generate the coseismic deformation maps by applying the Differential Synthetic Aperture Radar Interferometry (DInSAR) technique to SAR data collected along ascending and descending orbits by the Sentinel-1 constellation of the European Copernicus Programme. Then, we invert them through analytical modeling in order to better constrain the geometry and characteristics of the main source. The retrieved fault model revealed a shallow seismic source approximately NE–SW-striking and characterized by a left-lateral strike-slip, southeast-dipping faulting mechanism. Our retrieved solution reveals a new minor fault never mapped in geological maps before, whose kinematics is compatible with that of the surrounding structures and with the local and regional stress states. Moreover, we also use the preferred fault model to calculate the Coulomb Failure Function at the nearby receiver faults; taking into account the surrounding geological structures reported in literature, we show that all the considered receiver faults have been positively stressed by the main event. This is also confirmed by the distribution of the aftershocks that occurred near the considered faults. The analysis of the earthquake nucleated along these left-lateral strike-slip minor fault is essential to improve our knowledge of the East-Azerbaijan Plateau; therefore, further studies are required to evaluate their role in seismic hazard definition of northwest of Iran, in order to help in the mitigation of the seismic hazard in seismogenic regions unprepared for the occurrence of seismic events.This work is supported by: the 2019-2021 IREA-CNR and Italian Civil Protection Department agreement, H2020 EPOS-SP (GA 871121), ENVRI-FAIR (GA 824068) projects, and the I-AMICA (PONa3_00363) project.
During the last 20 years (1997 to 2017), four seismic sequences with Mw ≥ 5.5 mainshocks nucleated along the Central and Northern Apennines chain (Italy), causing casualties and damage: the 1997 Colfiorito, the 2009 L’Aquila, the 2012 Emilia, and the most recent 2016–2017 Central Italy seismic sequences. In this work, we perform a novel joint analysis of seismological and remote-sensing data to achieve new insights into the faulting process evolution during the considered seismic sequences. To this aim, we study these seismic sequences by exploiting the available seismological data and by applying fractals theory to them. In particular, we characterize the different behavior of compressional and extensional seismic sequences by examining the temporal evolution of the fractal dimension values. In addition, we compare the Differential Synthetic Aperture Radar Interferometry (DInSAR) displacement maps relevant to the considered seismic events (already published in our past papers) and the performed spatial and temporal seismological analyses, in order to emphasize some significant aspects of the different faulting processes active during these Italian seismic sequences. The analysis of the fractal dimension values shows that over time extensional seismic sequences are spatially distributed within a volume, whereas compressional ones are aligned along a preferential surface. These spatio-temporal patterns are confirmed by: (1) the spatial distribution of hypocenters for the events that occurred between the mainshock and the post-seismic synthetic aperture radar (SAR) acquisition; (2) the spatial extension of coseismic DInSAR ground-deformation patterns. The proposed seismic and ground-deformation analyses can thus typify different geodynamic contexts in Italy, providing a distinct image of articulated faulting processes.