Isabella D Guanche

Ms. Isabella D Guanche


Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 August 2025
Verified
Book Chapter
Closed access
PDF file
RPRachel Papavasilopoulos
Rachel Papavasilopoulos
RSRyan Scheinkman
Ryan Scheinkman
Sophie Madison BilikSophie Madison Bilik
Sophie Madison Bilik
AVAlexia Vignau
Alexia Vignau
IGIsabella D Guanche
Isabella D Guanche
KNKeyvan Nouri
Keyvan Nouri

21 August 2025
Verified
Book Chapter
Closed access
PDF file
RARahul Aggarwal
Rahul Aggarwal
IGIsabella D Guanche
Isabella D Guanche
GFGarrett D. Forman
Garrett D. Forman
RSRyan Scheinkman
Ryan Scheinkman
EBEdward Brotgandel
Edward Brotgandel
KNKeyvan Nouri
Keyvan Nouri

9 September 2026 in Bioengineering
Verified
Journal Article
Open access
PDF file
SSSavanah R. Sturm
Savanah R. Sturm
NMNicholas Alexander Mirsky
Nicholas Alexander Mirsky
ASAdriana Sandino
Adriana Sandino
MCMaria Castellon
Maria Castellon
ADAnshumi J. Desai
Anshumi J. Desai
PCPaulo G. Coelho
Paulo G. Coelho
Three-dimensionally (3D)-printed alpha-tricalcium phosphate (α-TCP) scaffolds, fabricated through a low-temperature hydrothermal dissolution-precipitation process, replicate the structural and compositional features of native bone. Reinforcing hydrothermally processed α-TCP with poly(lactic-co-glycolic acid) (PLGA) as a binder has previously been shown to confer distinct mechanical advantages, supporting its potential as a viable material for bone regenerative scaffolds. Although the hydrothermal processing of α-TCP scaffolds and PLGA-based mechanical reinforcement have each been characterized individually in earlier studies, this work represents the first pre-clinical in vivo assessment of osseoconduction and biocompatibility of 3D-printed, PLGA-reinforced, self-hardening calcium phosphate scaffolds in a large translational animal model. A ceramic ink suitable for extrusion was prepared by combining a 30 wt/vol% poloxamer 407 solution with α-TCP powder at a 0.45 wt/wt ratio (CTRL). A second extrudable ink, consisting of an α-TCP ceramic suspension incorporating a 35 wt/wt% PLGA binder, was formulated at a 0.5 wt/wt ratio (EXP). Cylindrical scaffolds (6 mm × 6 mm) were fabricated at room temperature using a custom-built Direct Ink Write 3D printer, then hydrothermally treated via submersion in water and thermal consolidation at 121 °C. Osteotomies were created in the ilium of adult sheep, with two cylindrical defects (7 mm × 6 mm) per animal, each receiving either a CTRL or EXP scaffold. Animals were euthanized at 3 and 12 weeks post-surgery (n = 6 animals per time point), and samples were collected en bloc for analysis. For both scaffold formulations, hard tissue formed by 12 weeks displayed high cellularity and active vascularization, consistent with early woven bone formation. Quantitative analysis revealed no significant between-group differences in bone formation at either time point (p > 0.05). These findings indicate that 3D-printed, PLGA-reinforced, self-hardening α-TCP scaffolds are osseoconductive and biocompatible, supporting their potential use in orthopedic and craniomaxillofacial bone defect repair.