This study presents experimental investigations of a hydrogen power unit operating on hydrogen–oxygen gas mixtures produced by water electrolysis (HHO gas). The system was operated with additional molecular hydrogen enrichment in order to investigate the influence of hydrogen concentration on combustion characteristics and system performance. The flame temperature of the HHO + H2 mixture was measured as a function of hydrogen concentration. The results show that the flame temperature increases nonlinearly with hydrogen content, approaching ~2800 °C under the investigated conditions at about 30 vol.% hydrogen in the enriched mixture. Despite the increase in flame temperature, the effective calorific value of the HHO + H2 mixture remains significantly lower than that of pure hydrogen because the electrolysis-derived gas contains oxygen and excess water vapor. The presence of water vapor acts as a thermal diluent, influencing combustion behavior and suppressing autoignition under the investigated operating conditions. Optimal operating parameters for the hydrogen power unit were determined from experimental measurements. The results indicate that hydrogen-enriched HHO mixtures can be operated safely under controlled conditions and may represent a potential working medium for hydrogen-based energy conversion systems.
In this work, we report the synthesis, characterization, and properties of Ni- and Ag-based plasmonic nanoparticles (PNPs) incorporated into a porous silicon (por-Si) matrix fabricated by masking the wafer surface using optical lithography and subsequent pore formation with the deposition of plasmonic-active metal nanoparticles (Me-PNPs) by single-stage metal-assisted electrochemical etching (EMACE). Preliminary masking of the silicon wafer surface using optical lithography and subsequent pore etching by the EMACE method with a simultaneous deposition of Me-PNPs allows for the fabrication of a periodic plasmonic structure, which demonstrates an enhancement of Raman signal, photoluminescence, and an improvement in water evaporation processes. Nickel-doped plasmonic structures created using photolithography and Ni+-ion implantation have high chemical stability due to the formation of nickel silicides (NiSi) in the surface layer. Silver-doped plasmonic structures on porous silicon, Ag-PNPs/por-Si, demonstrate a substantial enhancement of the Raman scattering signal at frequencies corresponding to the nanocrystalline phase, nc-Si, and high visible photoluminescence. The luminosity of silver plasmonic structures is due to the radiative properties of the Ag-PNPs/por-Si plasmonic structure, consisting of silver nanoparticles (Ag-PNPs) and porous silicon nanocrystallites (NC/por-Si). The calorific value of plasmonic structures on porous silicon Me-PNPs/por-Si depends on the time of the metal-stimulated etching of pores and the deposition of plasmonic nanoparticles (PNPs). The calorific value of the silver plasmonic structure Ag-PNPs/por-Si is higher than that of Ni-PNPs/por-Si and Ni/Ag-PNPs/por-Si. It exceeds the efficiency of known solar thermal vapor generators and is equal to Ea = 7.58 kg·m–2·h–1. The obtained results have important applied values in the technology of micro- and nanoelectronics for the fabrication of radiating devices and appliances using chemical, electrochemical etching methods; highly efficient solar thermal generators.