Recently, the passive seismic techniques based on the microtremor measurements have emerged as an alternative to conventional seismic and geotechnical methods used in engineering seismology and earthquake engineering, especially in the local site effect investigations. These methods are basically based on the recording of seismic ambient noise and analysis of its spectral features. Although these techniques are more practical than traditional seismic methods, the commercial instruments designed for recording the seismic ambient noise are quite expensive. Furthermore, most of these instruments require an external computer for recording and monitoring the data. In this sense, this paper intends to present a low-cost and Raspberry Pi single-board microcomputer aided seismic ambient noise recording and monitoring system (RaspMI) as an alternative to the computer aided commercial seismic noise measurement systems. RaspMI is an open-source hardware and software system that is controlled by a graphical user interface developed by using the MonoDevelop cross-platform and C# programming language. This system has many features such as 72 dB dynamic range, 100 Hz sampling frequency, timer recording mode, text and SAC data file format, and latitude, longitude, date and time support with GPS module. RaspMI has subjected to the various tests in terms of the reliability and sensitivity. The obtained results have shown that RaspMI can be used as an alternative instrument for seismic ambient noise measurements.
This paper presents an innovative approach based on hardware and software to develop a multichannel seismic monitoring and data acquisition embedded system. The hardware was designed by using basic electronic components and integrated circuits. It consists of two parts, signal processing and microcontroller circuits. The signal processing circuit is a combination of preamplifier, low-pass filter, gain control, high-pass filter, dc offset, and clipper circuits. The proposed data acquisition system is able to record data at a sampling rate of 300 μs, with 10-bit resolution. It has three modes: real-time monitoring, continuous recording, and seismic refraction. The detected seismic signals were filtered using analog filters, which are low pass with 1 kHz and high pass with 2 Hz. A universal serial bus was utilized to communicate between the hardware and the personal computer. A graphical user interface based on windows operating system was developed using Microsoft.NET Framework for transferring, processing, and analyzing the data. The system was tested and experimental results showing the performance of the proposed system were presented. Earth scientists can use this system for educational seismic experiments. It can be easily modified and used for other engineering applications.
4 September 2020 in Geoscientific Instrumentation, Methods and Data Systems
The commercial data acquisition instruments designed for three-component microtremor measurements are usually very expensive devices. In this paper, a low-cost, computer-aided, and geophone-based system designed to record, monitor, and analyze three-component microtremor data is presented. This proposed system is not a simple data acquisition system. It is also an integrated system developed to interpret the microtremor data using the horizontal-to-vertical spectral ratio (H ∕ V) method without any external software. Therefore, the H ∕ V peak frequency and amplitude can be easily estimated using this system. The proposed system has several features such as a 200 Hz sampling frequency, approximately 72 dB dynamic range, text data format, and data analysis tools. This system consists of a graphical user interface developed by using the .NET Framework 4.5.2 and external hardware that includes signal conditioning circuits, voltage converter circuit, external analog-to-digital converter, and Arduino Uno board. The proposed system uses low-cost vertical and horizontal geophones with a 4.5 Hz natural frequency to measure three-component microtremor data. The developed software undertakes many tasks such as communication between the external hardware and computer, transferring, monitoring, and recording the seismic data to the computer, and interpretation of the recorded data using the Nakamura method. Channel consistency and internal noise measurement tests were performed to demonstrate the accuracy and precision of the proposed system. The proposed system was compared to a commercial triaxial digital seismograph, and satisfactory results were obtained. The developed system is a completely open-source and open-hardware system and can be easily used in academic studies conducted by researchers and university students who are interested in seismic ambient noise analysis.