Petra Manshanden

Ms. Petra Manshanden


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 May 2022 in EPJ Photovoltaics
Verified
Journal Article
Open access
PDF file
PMPetra Manshanden
Petra Manshanden
GCGianluca Coletti
Gianluca Coletti
VRVictor Rosca
Victor Rosca
MJMark J. Jansen
Mark J. Jansen
KGKoen de Groot
Koen de Groot
SVSjoerd C. Veenstra
Sjoerd C. Veenstra
Improving the performance of solar modules requires the implementation of both spectral and directional irradiance optimization. The performance of bifacial four-terminal tandem minimodules with a 100 cm2 area is reported, both indoor and outdoor measurements. We demonstrate a 24.5 mW/cm2 (bifacial irradiance 200 W/m2) bifacial tandem power density, measured according to a tandem adapted IEC60904-1-2 protocol, which constitutes a 3 mW/cm2 gain with respect to monofacial use. In addition, we show that in outdoor measurements bifacial four terminal tandems outperform identical monofacial four terminal tandems by 26% on average, depending on incident angle, injection level and temperature, in a 10% albedo environment. The average gain is higher for outdoor performance than for indoor performance, due to variations in relative rear irradiance.

9 June 2026 in Solar RRL
Verified
Journal Article
Open access
PMPetra Manshanden
Petra Manshanden
MRMartijn Ronchetti
Martijn Ronchetti
MJMark Jansen
Mark Jansen
ASAlexandra Schmid
Alexandra Schmid
MHMinasadat Heydarian
Minasadat Heydarian
MSMartin Spath
Martin Spath
Outdoor performance indicates the end use performance of solar modules and is therefore essential to monitor for emerging technologies, preferably at an early stage to elucidate optimal improvement paths. We study the performance of triple‐junction perovskite–perovskite–silicon sample during 1 year outdoor by monitoring the performance in situ by performing I – V curves. It is shown that the temperature step necessary for encapsulation degraded the performance significantly; however, this power loss could be reclaimed after a few weeks outdoors. The degradation to a performance of 80% of original takes 4 months. Further degradation until 50% of original performance was reached after 6 months. This degradation is for a significant part due to degradation of the top and middle perovskite and transport layers. Although the voltage, current, and resistances degraded significantly, all three subcells remained operational until the end of the measurement period after a full year, although the sample changed from middle cell limited to top cell limited. During that year, the energy yield was 0.75 kWh/Wp, or 10% of available solar energy, which was caused by degradation of the perovskite and transport layers, decrease of shunt resistance and the suboptimal low‐light performance during the entire runtime.

7 February 2022
Verified
Conference Paper
Closed access
SVSjoerd Veenstra
Sjoerd Veenstra
RARonn Andriessen
Ronn Andriessen
VZValerio Zardetto
Valerio Zardetto
LSLukas Simurka
Lukas Simurka
HFHenri Fledderus
Henri Fledderus
GLGiulia Lucarelli
Giulia Lucarelli

16 February 2026 in Solar Energy Materials and Solar Cells
Verified
Journal Article
Closed access
PMPetra Manshanden
Petra Manshanden
BABas Van Aken
Bas Van Aken
GCGianluca Coletti
Gianluca Coletti
ACAlison Ciesla
Alison Ciesla