Research into enhancing the performance and flexibility of wearable microstrip patch antennas has emerged as a cutting-edge field, attracting significant attention from researchers globally. However, an adequate solution that leads to high antenna performance with high flexibility has not yet been found. Various research papers are analyzed from seven well-known online repositories and databases: IEEE Xplore, Directory of Open Access Journals, Science Direct, Springers Link, MDPI, Wiley Online Library and Google Scholar. In this study, three research questions concerning the types of materials and designs used and their impact on the performance of flexible wearable microstrip patch antennas are addressed. To investigate solutions to these questions, 46 related papers were identified via scientifically accepted review planning and conducting processes. Special focus is given to 2.5 GHz inset/strip line feeds with rectangular microstrip patch antennas. We found that copper-based conductive strips are widely used for flexible wearable microstrip patch antennas with high performance and low flexibility. On the other hand, newly emerging polymers, including graphene, PEDOT:PSS, PPy, and polyaniline, are also used in flexible microstrip patch antennas with low performance and high flexibility. Challenges and future research directions of the flexible wearable microstrip patch antennas’ current status are presented.
The atmospheric conditions and other facilities to rear silk filaments are good in Ethiopia. In Awassa, Awash Melkassa, and Kombolcha silk rearing is started with good progress. The quality of the cocoons produced in the country is not determined in relation to commercial silk produced in major silk producing countries. So far there was no information available about the basic properties of silk filaments produced. In this research paper, the different physical properties of the eri and mulberry cocoon and their filaments were evaluated. Eri cocoons have shell ratio of approximately 14%, average fiber fineness of 3 dtex, and average weight of 3.2–3.3 g, while mulberry cocoons have raw silk ratio of 13-14%, average fiber fineness of 2 dtex, and average weight of 1.5 g. Even though the method of rearing, handling, and harvesting of the cocoons is poor, the physical properties of the silk produced in Ethiopia fall within the limits of commercial silk produced in major silk producing countries.
Flexible conductive e-textiles for advanced technological applications, such as flexible antennas, require high electrical conductivity, flexibility, and durability. The use of conductive strips made of metals gives higher electrical conductivity at the expense of low flexibility, whereas polymers or carbon-based materials offer higher flexibility with lower electrical conductivity. Hybrid materials, such as metal and graphene nanoparticles coated fabrics, can be a solution to achieve optimum performance. Herein, the preparation of rGO-copper/graphene nanocomposite and coating on the fabric is demonstrated to develop flexible e-textiles. The ratio of copper (Cu) vs. graphene (Gr) is optimized, and structural analysis reveals that Cu nanoparticles are uniformly distributed on the surface of graphene layers. A higher amount of Cu shows higher aggregation of Cu nanoparticles and effectively fills the gaps between the graphene layers, resulting in higher packing. While a lower amount of Cu shows better locking of the Cu nanoparticles between the graphene sheets, and reduces the possibility of Cu nanoparticles oxidation. The lower amount of Cu in the composite results in higher flexibility and lower electrical conductivity. The developed e-textile with 31 wt% of Cu nanoparticles offer an optimum resistivity of 0.016 Ω-cm and flexural rigidity of 568 mg-cm. Fabrics coated with the nanocomposite having a higher Cu amount show higher resistance to bending and higher degradation after washing.
26 July 2026 in Journal of Materials Science: Materials in Electronics