The work evaluated the usage of various filler materials, namely aluminium oxide (Al2O3), magnesium (Mg), and glass powder, in the bidirectional glass fibre reinforced polymer (GFRP) composites. The required samples were fabricated using the hand lay-up technique by varying the filler material proportions from 0%wt. to 7.5%wt., including individual and hybrid mixture combinations. The prepared samples were evaluated for their microhardness, tensile strength, deflection characteristics, and drop-weight impact resistance. It was observed that the optimal addition of individual filler material improved the microhardness and tensile strength more than that of neat composites. In contrast, hybrid compositions at higher proportions exhibited brittleness and lower enactment due to their poor interfacial bonding and particle agglomerations. The deflection characteristics and drop-weight impact tests also showed enhanced stiffness and impact resistance with the addition of hybrid mixtures of filler materials to the composites. The study supports the potential use of adding filler materials to the composites for lightweight structural applications.
The newer methodology to improve the performance of cutting tool is by the constructive method of micro-texturing and green synthesized nanoparticles into the texture gaps for self-lubrication. Cross-chevron textures were made on the rake face of the cemented carbide tool using Neodymium Doped Yttrium Aluminium Garne (Nd-YAG) laser texturing machine. The environmentally friendly, non-hazardous and rapid method of producing nanoparticles was followed to produce Al2O3 nanoparticles. Various techniques used for characterizing the synthesized Al2O3 nanoparticles are Potential of Hydrogen (pH), Fourier Transform Infra-Red Spectroscopy Analysis (FTIR), Dynamic light scattering (DLS) and X-Ray Diffraction (XRD). The XRD shows the presence of required functional groups and the size of nanoparticles in the range of 500–550 nm. This article discusses the effect of textures, with and without nanoparticles filled on the texture gaps of the cemented carbide tool on the main cutting force, thrust force and co-efficient of friction while machining austenitic stainless steel 304. The combined effect of surface texturing and lubrication of Al2O3 nanoparticles enhanced the performance of the cutting tool compared with the conventional and textured tool.
The present study explores the methodology for the synthesis of bio-oil from waste trichosanthes cucumerina seeds by the solvent extraction method. It investigates the yield percentage, concentration of free fatty acids and acid contents in the extracted bio-oil. Effects of size of the crushed seeds, moisture content, extraction time, solvent to seed ratio and extraction temperatures were examined. The non-polar hexane solvent resulted in a higher percentage of oil yield (28.4 ± 0.4%) for the crushed seed size of 0.21 mm, 6% moisture content, 270 min extraction time, 68 °C temperature and 6:1(ml/g) of solvent to seed ratio. The synthesized bio-oil was characterized using Fourier Transform Infra-Red spectrum and Gas Chromatography–Mass Spectroscopy analysis. The properties of the bio-oil and biodiesel were assessed according to the American Society for Testing and Materials and the Association of Official Analytical Chemists standards. The obtained methyl-ester by trans-esterification process results in the fuel properties closer to the conventional fuel. Thus, Trichosanthes cucumerina bio-diesel can be used as a potential substitute.