A wavelength division multiplexed fiber Bragg grating (FBG) sensors interrogator using an integrated unbalanced Mach-Zehnder interferometer followed by an arrayed waveguide grating on silicon-on-insulator platform is presented. The Bragg wavelength-shift is determined through the phase-generated carrier demodulation technique, allowing accurate dynamic FBG interrogation. The performance of the proposed device was validated by comparing the measurements with a commercial FBG readout unit based on a spectrometer, serving as a reference. Experimental results demonstrate a dynamic strain resolution of 4.56 n $\epsilon$ / $\sqrt$ Hz and minimum detectable strain down to ~0.49 $\mu\epsilon$ at 1-kHz bandwidth.

We propose and experimentally demonstrate a long-range accelerated Brillouin optical time domain analysis (BOTDA) sensor that exploits the complementary noise reduction benefits of adaptive linear prediction and optical pulse coding. The combined technique allows using orders of magnitude less the number of averages of the backscattered BOTDA traces compared to a standard single pulse BOTDA, enabling distributed strain measurement over 10 km of a standard single mode fiber with meter-scale spatial resolution and 1.8 MHz Brillouin frequency shift resolution. By optimizing the system parameters, the measurement is achieved with only 20 averages for each Brillouin gain spectrum scanned frequency, allowing for an eight times faster strain measurement compared to the use of cyclic pulse coding alone.

We propose a novel high-power (up to 1.9 W) and low relative intensity noise (RIN) laser structure for effective first- and higher order distributed Raman copumping. RIN characterization and bit-error-rate measurements at 10 Gb/s point out RIN-penalty free transmission up to 25 dB of on-off copropagating Raman gain. This new copumping technology can provide sensible span reach enhancement in long-span unrepeated WDM transmission systems in a simple and effective way

Fiber Bragg Grating (FBG) sensors written by femtosecond laser pulses in polyamide-coated low bending loss optical fibers are succesfully embedded in carbon composite structures, following laminating and light resin moulding processes which optimize the size of each ply to address aesthetic, drapability and structural requirements of the final components. The sensors are interrogated by a tunable laser operating at around 1.55 μm and their response to temperature and strain variations is characterized in a thermally controlled chamber and by bending tests using suspended calibrated loads and a laser scanning system. Experimental results are in good agreement with simulations, confirming that the embedding process effectively overcomes potential issues related to FBG spectral distortion, birefringence and losses. In particular the effects of the composite material non homogeneity and FBG birefringence are investigated to evaluate their impact on the monitoring capabilities. A bi-material mechanical beam model is proposed to characterize the orthotropic laminates, pointing out better accuracy in estimating the applied load with respect to the classical homogeneous beam model. A comparative analysis, performed on different instrumented carbon composite samples and supported by theory, points out the repeatability of the FBG sensors embedding process and the effectiveness of the technology for real time accurate strain measurement. Based on such measurements damages and/or changes in local stiffness can be effectively detected, allowing for structural health monitoring of composite structures for applications in specific industrial fields like automotive and aerospace.