Wind energy is a commercially proven and rapidly developing type of electricity generation. Wind power plants with a vertical axis are more attractive and better suited for use in cities and urban environments where wind flow is less predictable compared to widespread wind power plants with a horizontal axis of rotation. This makes them a much better choice for both ground installation and/or for mounting on buildings and roofs that would otherwise limit the installation of higher horizontal turbine structures. The paper describes an experimental study of the drag force and its coefficient for wind turbines with a vertical axis of rotation. The object of the study is a laboratory model of a wind turbine with blades made in the form of rotating cylinders with a fixed blade. Experimental studies were carried out in the T-1-M wind tunnel, measurements of aerodynamic force were carried out using three-component scales. A distinctive feature of the work is the combined use of the lifting force of the cylinders, as well as the lifting force of the fixed plate. Due to this solution, when comparing with existing wind turbines with a vertical axis of rotation, it was found that the wind turbine in question prevails by 25‒100 % in the number of revolutions. The dependences of the drag force on the flow velocity and the drag coefficient on the Reynolds number from 1·104 to 4·104 are obtained. An uncertainty analysis was also carried out in order to determine the uncertainty by type A, B and the total uncertainty, from which it was found that the measurement error was 1.13 %. The field of the practical application of the results obtained in laboratory studies will be useful in the development of prototypes of wind turbines with a vertical axis of rotation
30 September 2025 in Bulletin of Toraighyrov University. Physics & Mathematics series
"It is known that electrical discharge strikes can cause the formation of active free radicals, atomic oxygen and hydrogen, nitrogen compounds, and even simple amino acids in water. Air and other gases dissolved in water contribute to the realization of these processes. Based on the fact that the electrohydraulic effect is a powerful source of ultrasound, it can be assumed that ultrasound is one of the main factors influencing microorganisms. Given that the electrohydraulic effect is a powerful source of ultrasound, it can be assumed that ultrasound is one of the primary causes of the intense destruction of microorganisms. The vigorous oxidative action of atomic oxygen, which is formed during electrical discharge strikes, literally burns all organic matter present in the water. Experiments have shown that direct discharge exposure is lethal to microorganisms suspended in the liquid, and the liquid obtained after the corresponding electrohydraulic treatment acquires induced bactericidal properties that do not diminish over time. Keywords: electrical discharge treatment, electrohydraulic effect, specific electrical conductivity (SEC), salt content, TDS- meter."
30 September 2026 in Bulletin of the Karaganda University "Physics Series"
This study investigates the effect of electrohydraulic pulse treatment on changes in the physicochemical parameters of wastewater and the analytical signals of heavy metals. The relevance of the study is determined by the need to develop reagent-free methods for the advanced treatment of industrial and municipal-industrial wastewater containing organic pollutants and trace metal impurities. The treatment was carried out in a laboratory high-voltage cell with an interelectrode discharge in an aqueous medium. Wastewater from the pumping station of JSC “Qarmet” in Temirtau was used as the study object. Heavy metals were determined by stripping voltammetry, while changes in the chemical parameters were assessed based on COD, BOD₅, pH, ammonium nitrogen, phenols, petroleum products, total iron, and chromium content. After treatment, COD decreased from 95.9 to 69.0 mg/dm³, corresponding to a reduction of 28.1%. The BOD₅/COD ratio increased from 0.095 to 0.155, indicating an improvement in the biodegradability of the organic compounds. The analytical signals of Zn, Cd, Pb, and Cu decreased by 82.7–100%. The obtained results demonstrate the potential of electrohydraulic pulse treatment as a pretreatment or advanced treatment stage for complex wastewater.
Plasma-pulse water treatment using a high-voltage underwater spark discharge is a reagent-free approach with potential for simultaneous disinfection and physicochemical modification of water. In this study, a laboratory-scale recirculating reactor (Vtot = 10 L) equipped with a storage capacitor of C = 0.25 μF was operated at U = 15–30 kV and a pulse repetition frequency of about 1.8 Hz to evaluate disinfection performance and system-level energy characteristics for two water matrices, surface wastewater and tap water. The corresponding calculated capacitor-stored energy ranged from 28.1 to 112.5 J per pulse. Microbiological and physicochemical measurements were performed in triplicate. At U = 30 kV, the total microbial count in wastewater decreased from approximately 1 × 105 CFU/mL to below the method detection limit (LOD = 1 CFU/mL) within 2–3 min. For the 2 min/10 L operating mode, the system-level specific energy input was estimated at 6.7 kWh/m3. During the initial treatment period, temperature-compensated conductivity (σ25) decreased by 3–8%, depending on the water matrix, and then increased with prolonged treatment. These results show that the tested reactor can provide rapid reagent-free reduction in culturable microflora under the studied conditions. However, plasma-pulse treatment should be regarded primarily as an advanced treatment, polishing, or pre-treatment option for complex water matrices rather than as a universal replacement for conventional large-volume disinfection technologies.