This paper presents a novel approach to design a heterostructure demultiplexer using the ring resonators in a solid–solid phononic crystal (PnC). The proposed PnC structure is a square lattice contained circular tungsten cylinders embedded in a polycrystalline silicon background. The heterostructure-based demultiplexer consists of three different sections, where every section includes a bus waveguide and an output waveguide coupled to each other through a special ring resonator. The simulation results show that different frequencies emitted from the heterostructure demultiplexer outputs in the range of GHz. The achieved maximum and minimum transmissions are about 88% and 42%. Furthermore, the very high average quality factor of 4570 results are among output channels. Moreover, the maximum crosstalk (the worst one) among the outputs is −13 dB, which is a desirable value. Finally, the effect of temperature variations on the demultiplexer performance is explored. It is revealed that by enhancing the constituted material temperature the resonance frequencies decrease almost linearly and gradually.
25 January 2022 in The European Physical Journal Plus
We show the evolution of two fundamental bright solitons after being simultaneously launched into nonlinear triangular parity time (PT) symmetric waveguides, at mirrored transverse input positions. Numerical simulations show, whether below or above the phase transition, in general the retarded soliton propagating along the gain side and the advanced soliton evolving along the loss side of either waveguide interfere incoherently, within the interacting regime. In non-interacting regime, however, each soliton evolves as it has been launched individually. When beyond the phase transition, the unstable solitons become self-trapped after traversing relatively short distances. The incoherent interference alters the projectile of each soliton from that of the one launched individually at the same initial input position. The temporal dynamics of interacting solitons along PT symmetric waveguide, due to the interplay of nonlinearity and the active elements, are not periodic. This is in contrast to the interaction dynamics along the purely index guided cell. The results suggest that appropriately designed nonlinear PT symmetric waveguides, below or above the phase transition, can play the role of key elements in design and fabrication of optical gates, isolators, and switches.
In this article, an optical isolator is designed and simulated based on a hybrid configuration of the photonic crystal (PhC) and graphene. The PhC membrane is a hexagonal lattice of air holes arranged in a nonlinear silicon substrate. To provide a nonreciprocal transmission (optical isolator), breaking the symmetry of the light propagation path (the forth and back routes) is an essential condition. Here, the asymmetrical round trip of the light propagation and the Kerr-nonlinear effect are employed to obtain asymmetric propagation. The isolator structure includes a PhC waveguide that asymmetrically side-coupled to a specific embedded cavity. Then, to attain a tunable asymmetric transmission, a Nano-layer of graphene is located on the top of the mentioned PhC configuration. By altering the chemical potential of graphene one can control the isolation rate, frequency, and bandwidth of offered structure and thus possess a tunable optical isolator. The simulation results show that a 0.5 nm frequency shift can attain by the graphene chemical potential alterations from 0.45 eV to 0.65 eV in which it is suitable for Dense Wavelength Division Multiplexing (DWDM) communication and integrated optical circuits. Furthermore, as another advantage, a high forward normalized transmission (0.6) has resulted in a large average isolation rate of 32.5 dB due to low losses of the proposed structure.
15 October 2020 in Journal of Electronic Materials