Recently, due to the miniaturization of electronic products, printed circuit boards (PCBs) have also become smaller. This trend has led to the need for high-precision electrical test equipment to check PCBs for disconnections and short circuits. The purpose of this study is to improve the position repeatability of the platform unit up to ±2.5 μm in linear stage type test equipment. For this purpose, the causes of the position errors of the platform unit are analyzed. The platform unit holding the PCB is driven by a single-axis linear ball screw drive system offset from its geometric center due to design constraints. The yaw rotation of the platform is found to have a dominant effect on position repeatability. To address this problem, adding balancing weights to the platform unit and adjusting the stiffness of the LM Guides are proposed. These methods reduce the yaw rotation by moving the centers of mass and stiffness closer to the linear ball screw actuator. In the verification tests, the position repeatability was decreased to less than ±1.0 μm.
Solid oxide fuel cells (SOFCs) are a promising near-zero-emission propulsion source for Northern Sea Route (NSR) vessels, but their yttria-stabilized zirconia (YSZ) electrolyte and Ni-cermet anode are susceptible to thermomechanical degradation under repetitive start–stop thermal cycling. We develop a hierarchical Bayesian competing-risk framework built on a dual degradation model that decomposes area-specific resistance (ASR) growth into cycle-induced fatigue and time-dependent electrochemical aging and apply it across six NSR duty-cycle scenarios spanning f = 1–27 cycles/month. Posterior inference via the No-U-Turn Sampler (NUTS) yields 17 estimated parameters meeting standard convergence criteria (R^ ≤ 1.01, ESSbulk ≥ 479, zero divergent transitions). The analysis identifies a failure-mode transition at f ≈ 3–6 cycles/month: high-frequency routes are crack-dominated (S1a: 10/15 cells fail by crack within the 600-cycle window with 5/15 right-censored), whereas low-frequency routes are ASR-dominated (S3b: 100% ASR). Global sensitivity analysis indicates the time-dependent rate coefficient ktime as the primary remaining-useful-life driver (ST = 0.37–0.46). Cycle-based maintenance thresholds span 160 cycles (S3b) to ≥600 cycles (S2b), bracketed by S1a (270 cycles, 10.0 months, crack-dominant) and S3a (480 cycles, 160 months, transition regime); qualitative consistency with published experimental data supports physical plausibility.