Clean or Dirty: Aerosols strongly affect atmospheric properties and processes—including visibility, cloud formation, and radiative behavior. Knowing their effects in both clean and polluted air is necessary in order to understand their influence (see the Perspective by Baltensperger ). Clarke and Kapustin (p. 1488 ) examine vertical atmospheric profiles collected above the Pacific Ocean, where air quality is affected by the transport of polluted air from the west, and find significant regional enhancements in light scattering, aerosol mass, and aerosol number associated with combustion. Aerosol particle concentrations in this region can exceed values in clean, unperturbed regions by over an order of magnitude. Thus combustion affects hemispheric aerosol optical depth and the distribution of cloud condensation nuclei. Pöschl et al. (p. 1513 ) discuss the composition of aerosols above the Amazon Basin, in the pristine conditions of the rainy season. The aerosols in this region are derived mostly from gaseous biogenic precursors, plants, and microorganisms, and particle concentration is orders of magnitude lower than in polluted continental regions.

Experimental and theoretical uncertainties in the measurement of cloud condensation nuclei (CCN) with a continuous-flow thermal-gradient CCN counter from Droplet Measurement Technologies (DMT-CCNC) have been assessed by model calculations and calibration experiments with ammonium sulfate and sodium chloride aerosol particles in the diameter range of 20–220 nm. Experiments have been performed in the laboratory and during field measurement campaigns, covering a wide range of instrument operating conditions (650–1020 hPa pressure, 293–303 K inlet temperature, 4–34 K m⁻¹ temperature gradient, 0.5–1.0 L min⁻¹ flow rate). For each set of conditions, the effective water vapor supersaturation (S_eff, 0.05–1.4%) was determined from the measured CCN activation spectra (dry particle activation diameters) and Köhler model calculations. High measurement precision was achieved under stable laboratory conditions, where the relative standard deviations of S_eff were as low as ±1%. During field measurements, however, the relative deviations increased to about ±5%, which can be mostly attributed to variations of the CCNC column top temperature with ambient temperature. The observed dependence of S_eff on temperature, pressure, and flow rate was compared to the CCNC flow model of Lance et al. (2006). At high S_eff the relative deviations between flow model and experimental results were mostly less than 10%, but at S_eff≤0.1% they exceeded 40%. Thus, careful experimental calibration is required for high-accuracy CCN measurements – especially at low S_eff. A comprehensive comparison and uncertainty analysis of the various Köhler models and thermodynamic parameterizations commonly used in CCN studies showed that the relative deviations between different approaches are as high as 25% for (NH₄)₂SO₄ and 12% for NaCl. The deviations were mostly caused by the different parameterizations for the activity of water in aqueous solutions of the two salts. To ensure comparability of results, we suggest that CCN studies should always report exactly which Köhler model equations and parameters were used. Provided that the Aerosol Inorganics Model (AIM) can be regarded as an accurate source of water activity data for highly dilute solutions of (NH₄)₂SO₄ and NaCl, only Köhler models that are based on the AIM or yield similar results should be used in CCN studies involving these salts and aiming at high accuracy. Experiments with (NH₄)₂SO₄ and NaCl aerosols showed that the conditions of particle generation and the shape and microstructure of NaCl particles are critical for their application in CCN activation experiments (relative deviations up to 18%).

Interactions with water are crucial for the properties, transformation and climate effects of atmospheric aerosols. Here we present a conceptual framework for the interaction of amorphous aerosol particles with water vapor, outlining characteristic features and differences in comparison to crystalline particles. We used a hygroscopicity tandem differential mobility analyzer (H-TDMA) to characterize the hydration and dehydration of crystalline ammonium sulfate, amorphous oxalic acid and amorphous levoglucosan particles (diameter ~100 nm, relative humidity 5–95% at 298 K). The experimental data and accompanying Köhler model calculations provide new insights into particle microstructure, surface adsorption, bulk absorption, phase transitions and hygroscopic growth. The results of these and related investigations lead to the following conclusions: (1) Many organic substances, including carboxylic acids, carbohydrates and proteins, tend to form amorphous rather than crystalline phases upon drying of aqueous solution droplets. Depending on viscosity and microstructure, the amorphous phases can be classified as glasses, rubbers, gels or viscous liquids. (2) Amorphous organic substances tend to absorb water vapor and undergo gradual deliquescence and hygroscopic growth at lower relative humidity than their crystalline counterparts. (3) In the course of hydration and dehydration, certain organic substances can form rubber- or gel-like structures (supramolecular networks) and undergo transitions between swollen and collapsed network structures. (4) Organic gels or (semi-)solid amorphous shells (glassy, rubbery, ultra-viscous) with low molecular diffusivity can kinetically limit the uptake and release of water and may influence the hygroscopic growth and activation of aerosol particles as cloud condensation nuclei (CCN) and ice nuclei (IN). Moreover, (semi-)solid amorphous phases may influence the uptake of gaseous photo-oxidants and the chemical transformation and aging of atmospheric aerosols. (5) The shape and porosity of amorphous and crystalline particles formed upon dehydration of aqueous solution droplets depend on chemical composition and drying conditions. The apparent volume void fractions of particles with highly porous structures can range up to ~50% or more (xerogels, aerogels). (6) For efficient description of water uptake and phase transitions of aerosol particles, we propose not to limit the terms deliquescence and efflorescence to equilibrium phase transitions of crystalline substances. Instead we propose generalized definitions according to which amorphous and crystalline components can undergo gradual or prompt, partial or full deliquescence or efflorescence. We suggest that (semi-)solid amorphous phases may be important not only in the upper atmosphere as suggested in recent studies of glass formation at low temperatures. Depending on relative humidity, (semi-)solid phases and moisture-induced glass transitions may also play a role in gas-particle interactions at ambient temperatures in the lower atmosphere.

The Amazon Basin plays key roles in the carbon and water cycles, climate change, atmospheric chemistry, and biodiversity. It has already been changed significantly by human activities, and more pervasive change is expected to occur in the coming decades. It is therefore essential to establish long-term measurement sites that provide a baseline record of present-day climatic, biogeochemical, and atmospheric conditions and that will be operated over coming decades to monitor change in the Amazon region, as human perturbations increase in the future. The Amazon Tall Tower Observatory (ATTO) has been set up in a pristine rain forest region in the central Amazon Basin, about 150 km northeast of the city of Manaus. Two 80 m towers have been operated at the site since 2012, and a 325 m tower is nearing completion in mid-2015. An ecological survey including a biodiversity assessment has been conducted in the forest region surrounding the site. Measurements of micrometeorological and atmospheric chemical variables were initiated in 2012, and their range has continued to broaden over the last few years. The meteorological and micrometeorological measurements include temperature and wind profiles, precipitation, water and energy fluxes, turbulence components, soil temperature profiles and soil heat fluxes, radiation fluxes, and visibility. A tree has been instrumented to measure stem profiles of temperature, light intensity, and water content in cryptogamic covers. The trace gas measurements comprise continuous monitoring of carbon dioxide, carbon monoxide, methane, and ozone at five to eight different heights, complemented by a variety of additional species measured during intensive campaigns (e.g., VOC, NO, NO₂, and OH reactivity). Aerosol optical, microphysical, and chemical measurements are being made above the canopy as well as in the canopy space. They include aerosol light scattering and absorption, fluorescence, number and volume size distributions, chemical composition, cloud condensation nuclei (CCN) concentrations, and hygroscopicity. In this paper, we discuss the scientific context of the ATTO observatory and present an overview of results from ecological, meteorological, and chemical pilot studies at the ATTO site.

Phase transitions of nanoparticles are of fundamental importance in atmospheric sciences, but current understanding is insufficient to explain observations at the nano-scale. In particular, discrepancies exist between observations and model predictions of deliquescence and efflorescence transitions and the hygroscopic growth of salt nanoparticles. Here we show that these discrepancies can be resolved by consideration of particle size effects with consistent thermodynamic data. We present a new method for the determination of water and solute activities and interfacial energies in highly supersaturated aqueous solution droplets (Differential Köhler Analysis). Our analysis reveals that particle size can strongly alter the characteristic concentration of phase separation in mixed systems, resembling the influence of temperature. Owing to similar effects, atmospheric secondary organic aerosol particles at room temperature are expected to be always liquid at diameters below ~20 nm. We thus propose and demonstrate that particle size should be included as an additional dimension in the equilibrium phase diagram of aerosol nanoparticles.

Black carbon (BC) and organic carbon (OC) are the largest contributors to the aerosol absorption in the atmosphere, yet the absorption cross sections of BC and OC per unit mass are subject to a large uncertainty due to morphology, physicochemical properties, and the mixing state of carbonaceous particles. Theoretical studies suggest the possibility of an enhanced absorption by soot–cloud drop agglomerates; however, the magnitude of the effect has never been measured directly and remains highly uncertain. This study is a laboratory experiment aimed at the modeling of direct radiation forcing due to soot‐water interaction in the presence of glutaric acid, a water‐soluble OC. Specifically, we generate, in the laboratory, hydrophobic soot (acetylene soot) and hydrophilic soot (mixture of acetylene soot and glutaric acid) and investigate the structural and optical properties of hydrophobic and hydrophilic soot particles in dry and water‐saturated air. Hydrophobic soot (HBS) particles do not exhibit any structural or morphological differences under dry and saturated conditions, whereas hydrophilic soot (HLS) particles, i.e., BC with a monolayer of glutaric acid, collapse into globules when relative humidity (RH) is increased to saturation. The optical properties of HBS show very little dependence on RH while HLS scattering and absorption coefficient increase markedly with RH. For the cases considered here, the maximum enhancement in absorption for a soot–water drop mixture was as much as a factor of 3.5, very similar to theoretical predictions. The data provided in this study should advance the treatment of polluted cloud layers in climate models.