The EU directive 2024/1990/EU mandates a fourth treatment stage for micropollutant removal in wastewater treatment plants (WWTPs). Porous carbonaceous materials (PCMs) such as powdered activated carbon (PAC) and biochar are effective but require monitoring. This study presents a semi-quantitative, low-cost method for PCM determination in wastewater matrices using total carbon (TC) analysis. Calibration curves were established for activated sludge (AS), excess sludge (ES) and anaerobic digestion sludge (ADS) matrices, yielding high linearity ( R2 > 0.99). Limits of detection (LOD) and quantification (LOQ) ranged from 0.10 to 0.25 gPCM/gDM. Recovery rates exceeded 95% for AS and ES matrices, with relative standard deviations below 5%, demonstrating excellent precision. Comparison with chemical oxygen demand (COD)-based estimates showed strong correlation, validating the approach. The method enables routine PCM monitoring in WWTPs lacking sophisticated analytical equipment, supporting regulatory compliance and process optimization. While native organic carbon cannot be excluded and the relatively high LOD reduces sensitivity, the method still delivers robust semi-quantitative estimates for basic routine PCM monitoring.
7 August 2026 in Journal of Environmental Management
Anaerobic digestion stability during high organic loading remains challenging in wastewater treatment plants. This study investigated whether introducing bio-based gasification char (BGC) directly to digesters versus indirectly via upstream application in activated sludge treatment (e.g. for micropollutant adsorption) affects process stability and microbial responses. Six mesophilic, semi-continuous reactors operated under stepwise increasing organic loading demonstrated dosing strategy dependent mechanisms. Direct BGC addition induced extensive microbial restructuring, enriching hydrogenotrophic and acetoclastic methanogens as well as syntrophic bacteria. This conferred extreme stress resilience at 4-fold initial loading as shown by BGC reactors which maintained high methane production while controls collapsed. Conversely, indirect BGC addition via preconditioned sludge maintained moderate stability without significant community restructuring despite comparable BGC concentrations indicating substrate-mediated buffering rather than community-mediated optimization. Functional analysis revealed gradual metabolic pathway upregulation within existing taxa. Differences in surface chemistry explained the divergent outcomes. Fresh BGC provides a pristine alkaline surface (pH 9 - 10), which enables biofilm colonization and direct interspecies electron transfer. In contrast, upstream treatment neutralises the alkalinity (pH 7.10) and exhausts the adsorptive capacity. Direct BGC enables extreme stress resistance through microbial community optimization, while indirect BGC supports operational stability with minimal disruption, enabling dosing strategy selection based on operational priorities in full-scale WWTPs.
Bio-based gasification char (BGC) is being considered for use in the fourth stage of wastewater treatment aiming on organic micropollutants (OMPs) removal. However, when OMP-loaded BGC enters anaerobic digestion via sludge, the adsorbed compounds may inhibit microbial- in general and methanogenic activity in particular. This study assessed the impact of OMP-loaded BGC on the performance of anaerobic batch digestion under mesophilic conditions. Six compounds (benzotriazole, sulfamethoxazole, valsartan, metoprolol, carbamazepine and diclofenac) were tested in reactors containing OMP-loaded BGC, OMPs only and two reference conditions over 40 days. No significant differences in final cumulative methane yield were detected between the BGC and non-BGC conditions for any compound. Modified Gompertz modelling revealed compound-specific kinetic effects: sulfamethoxazole without BGC caused complete process inhibition until day 14, whereas valsartan with BGC exhibited reduced methane production. BGC was found to reduce acidification of the reactor across all compounds. The removal of OMPs was found to be significantly higher in the BGC group compared to non-BGC conditions, where only SMX was fully removed, with recalcitrant compounds reaching only 14 – 36 %. This difference was particularly evident for recalcitrant compound carbamazepine, suggesting that strong adsorption might be the predominant removal pathway. These findings support the closed-loop BGC system, while also highlighting the need to consider the kinetic risks of individual compounds and the fate of adsorbed OMP`s during digestion.
Anaerobic digestion stability during high organic loading remains challenging in wastewater treatment plants. This study investigated whether introducing bio-based gasification char (BGC) directly to digesters versus indirectly via upstream application in activated sludge treatment (e.g. for micropollutant adsorption) affects process stability and microbial responses. Six mesophilic, semi-continuous reactors operated under stepwise increasing organic loading demonstrated dosing strategy dependent mechanisms. Direct BGC addition induced extensive microbial restructuring, enriching hydrogenotrophic and acetoclastic methanogens as well as syntrophic bacteria. This conferred extreme stress resilience at 4-fold initial loading as shown by BGC reactors which maintained high methane production while controls collapsed. Conversely, indirect BGC addition via preconditioned sludge maintained moderate stability without significant community restructuring despite comparable BGC concentrations indicating substrate-mediated buffering rather than community-mediated optimization. Functional analysis revealed gradual metabolic pathway upregulation within existing taxa. Differences in surface chemistry explained the divergent outcomes. Fresh BGC provides a pristine alkaline surface (pH 9 - 10), which enables biofilm colonization and direct interspecies electron transfer. In contrast, upstream treatment neutralises the alkalinity (pH 7.10) and exhausts the adsorptive capacity. Direct BGC enables extreme stress resistance through microbial community optimization, while indirect BGC supports operational stability with minimal disruption, enabling dosing strategy selection based on operational priorities in full-scale WWTPs.
Antimicrobial resistance genes threaten the effective treatment of infectious diseases, underscoring the importance of their control in line with the EU One Health policy. Wastewater treatment plants are recognized hotspots for antimicrobial resistance. We assessed whether multi-channel mixed-matrix membranes (MCMMMs)—polyethersulfone (PES)/polyvinylpyrrolidone (PVP) ultrafiltration membranes with embedded activated carbon—can concurrently reduce microorganisms and extracellular DNA in wastewater effluent, building on prior reports of micropollutant removal. We evaluated the performance of MCMMMs in removing Escherichia coli and Saccharomyces cerevisiae as model organisms, as well as colony-forming units (CFUs) from wastewater effluent at a transmembrane pressure of 1 bar with a filtration area of 66 cm2 over 1 h. DNA was extracted from wastewater effluent following filtration and analyzed to assess changes in microbial community composition. MCMMMs achieved log10 reductions of 5.47 ± 0.42 (Escherichia coli), 5.99 ± 0.46 (Saccharomyces cerevisiae), and 2.79 ± 0.31 (wastewater CFU); reductions by pure PES/PVP membranes were comparable: higher for Escherichia coli and wastewater CFUs, lower for Saccharomyces cerevisiae. Amplicon sequencing showed altered relative abundances in wastewater effluent. Collectively, these findings demonstrate the potential of MCMMMs to simultaneously remove microorganisms, extracellular DNA, and micropollutants, highlighting their suitability for water treatment applications within the One Health framework.