Agricultural intelligent manipulators are essential for autonomous operations in smart agriculture. However, their industrial deployment faces critical bottlenecks, including perception failures, crop damage, and poor cost–benefit ratios in unstructured environments. Following the PRISMA guidelines, this study reviewed 22 key representative studies and 78 related studies (2015–2026). This review analyzes mechanisms for low-damage and high-precision operations across hardware (rigid–flexible structures), perception (multi-modal fusion), and decision-making (intelligent control). We compare operational efficiency and damage rates in harvesting, transplanting, and sorting, finding that rigid–flexible actuators with vision-guided force control are key to overcoming current limitations. To evaluate these technologies, we established a benchmarking framework across fruit/vegetable harvesting, seedling grafting, and precision plant protection to assess four technological trajectories. We also address engineering challenges: machinery–agronomy misalignment, high sensor costs, and limited edge computing. Notably, we introduce an economic payback period analysis to evaluate commercial feasibility. Ultimately, future research should prioritize lightweight variable-stiffness hardware, synchronous visuo-tactile perception, and digital twins to seamlessly integrate machinery and agronomy.
Urea discharge can become unstable as interparticle cohesion increases under moisture-affected conditions. This study combined bulk-solid mechanics, discrete element method (DEM) simulations, contact parameter calibration, and bench testing to investigate urea arching and vibration-assisted discharge. Dry-contact parameters for urea particles and a polypropylene (PP) hopper were calibrated using angle-of-repose and sliding tests. The calibrated simulations differed from the physical target values by 1.71% for the angle of repose and 3.98% for the sliding friction angle. In a separate DEM sensitivity analysis, JKR surface energy was prescribed at 0, 0.05, 0.15, and 0.30 J·m−2 as an effective adhesion parameter rather than as a calibrated moisture state. The maximum EDEM-exported Total Force signal increased from 2.283 N at 0 J·m−2 to 2.704 N at 0.30 J·m−2 (18.5%), whereas the mean particle velocity during the common 5–18 s pre-discharge interval decreased from 0.0613 to 0.0397 m·s−1 (35.3%). Two combined excitation settings were evaluated: 29.17 Hz/0.2 mm and 58.33 Hz/1.2 mm. Because frequency and amplitude changed simultaneously, their individual effects could not be isolated. The bench tests yielded mean discharged masses of 566.808, 492.435, and 464.305 g for the 58.33 Hz/1.2 mm, 29.17 Hz/0.2 mm, and non-vibrating conditions, respectively. The 58.33 Hz/1.2 mm setting increased the mean mass discharged during the 30 s collection interval by approximately 22.1% relative to the non-vibrating control. The corresponding between-run coefficients of variation were 3.628%, 3.580%, and 4.303%; these values describe repeatability between replicate runs rather than temporal or spatial discharge uniformity. Overall, increasing prescribed adhesion reduced particle mobility in the DEM simulations, whereas the 58.33 Hz/1.2 mm combined excitation increased discharged mass under the tested conditions. The experiments do not directly demonstrate crystal bridge rupture or isolate an independent frequency effect.