Liquefied Petroleum Gas (LPG) is a fossil fuel widely used in residential, commercial, and industrial applications. LPG systems must be designed and sized under minimum safety standards, which are established in national and international regulations. An LPG system is composed of fuel storage containers, pipelines, valves, meters, consumption equipment, and protection and safety elements. These must be sized and selected to withstand the action of the fuel gas and the working conditions to which they will be subjected. This document presents a review of the most important points to consider in the design and sizing of an LPG system based on the most representative international regulations. El gas licuado de petróleo (GLP) es un combustible de origen fósil ampliamente utilizado en aplicaciones residenciales, comerciales e industriales. Los sistemas de GLP deben diseñarse y dimensionarse bajo estándares mínimos de seguridad, los cuales son establecidos en normativas nacionales e internacionales. Un sistema de GLP está conformado por recipientes de almacenamiento del combustible, tuberías, válvulas, medidores, equipos de consumo y elementos de protección y seguridad. Estos deben ser dimensionados y seleccionados para soportar la acción del gas combustible y las condiciones de trabajo a las que serán sometidos. En este documento se presenta una revisión de los puntos más importantes a tener en cuenta en el diseño y dimensionamientos de un sistema de GLP a partir de las normativas más representativas a nivel internacional.
Current air pollution episodes from fine particulate matter (PM2.5) in the Concepción Metropolitan Area generate a necessity to assess alternatives to reduce these emissions under different regulatory schemes. The study shows that for greater availability of natural gas at low prices, fuel substitution would be an attractive alternative for the industrial facilities. In particular, for those industrial facilities using fuel oil, fuel substitution for natural gas may occur even without regulatory requirements due to cost savings. For those equipment that use biomass as an energy source, fuel substitution may occur depending on fuel prices and regulatory requirements, while boilers that uses coal are likely to implement an emission control technology.
Residential heater replacement programs in Chile have been evaluated primarily through fine particulate matter (PM) reduction metrics, without considering chemical speciation of the organic aerosols. This screening-level study characterized and compared particle-bound polycyclic aromatic hydrocarbon (PAH) and nitro-PAH emission factors from a residential firewood and a wood pellet heater, under controlled combustion conditions, and assessed their potential toxic equivalency (BaP-TEQ). Compound quantification used 1-nitropyrene as an index calibration compound; all results are semi-quantitative estimates with a combined analytical uncertainty of approximately 13–32%. Firewood combustion yielded a PAH-dominated emission profile with a total BaP-TEQ EF of 187.8 ng/kg, driven primarily by benzo[a]pyrene (BaP; individual contribution: 183.9 ng/kg). Wood pellet combustion showed a nitro-PAH-dominated profile under the applied semi-quantitative analytical conditions, with concentrations expressed as 1-nitropyrene-equivalent estimates and several compounds identified tentatively by NIST library matching, yielding a total screening-level BaP-TEQ EF of 972.1 ng/kg, approximately five-fold higher than firewood under the applied TEF framework and driven primarily by 6-nitrochrysene (toxic equivalency factor, TEF = 10). This screening-level estimate should not be interpreted as a direct human health risk between the two heating systems. Mean PM emission factors were 1.05 ± 0.55 g/kg for firewood combustion and 0.69 ± 0.15 g/kg for pellet combustion (approximately 1.5-fold difference). These results are reported descriptively given the screening-level nature of the analysis. The shift in particulate chemical profile from PAH-dominated in the firewood system to nitro-PAH-dominated in the pellet system suggests that wood pellets from pine may not be a sustainable approach to address air quality problems in Chile, since reductions in PM emissions alone may not capture relevant differences in the organic toxicological profile between these combustion systems. These findings provide a regional baseline for the chemical speciation of residential biomass emissions in Chile.