Background: Nitroaromatic compounds are important scaffolds used for the syn-thesis of a variety of compounds, such as explosives, herbicides, dyes, perfumes and phar-maceuticals. Bismuth nitrate pentahydrate is a widely used reagent in organic synthesis; how-ever, its utility as a nitrating agent for anilines is underexplored. Objective: The aim of this work is to propose and find the proper reaction conditions of an alternative nitrating agent constituted by a mixture of bismuth nitrate / acetic anhydride in DCM with a series of substituted anilines under mild reflux. Methods: Several anilines having both activating and deactivating substituents in the ortho, meta and para positions were the substrate for the nitration reaction. Experimental conditions were performed in “one-pot” conditions before product purification. Results: Bi(NO3)3•5H2O demonstrated to be effective and somehow regioselective when it came to the nitration of anilines in the ortho position. Although other products were also identified under these conditions, in most cases, the ortho derivative was the major or even the only product obtained with moderate to high yields in the range of 50% – 96%. Conclusion: Bi(NO3)3•5H2O is an efficient and safe nitrating agent since the use of concen-trated and corrosive acids like sulfuric and nitric is avoided; furthermore, bismuth nitrate is low-priced and no special care nor equipment is required.
This research focused on the development and characterisation of molecularly imprinted polymers (MIPs) modified with titanium dioxide (TiO2) for the adsorption and photocatalytic degradation of sodium naproxen (NPX). Different percentages of TiO2 (5% and 25%) were tested and compared to non-imprinted polymers (NIPs). FT-IR analysis confirmed the interaction between methacrylic acid and TiO2, promoting the formation of specific binding sites and presenting a good imprinting factor. The results showed that the MIP with 5% TiO2 had the highest adsorption and retention capacity, attributed to the imprinting effect and the reduced interference from TiO2. The surface of the MIPs is heterogeneous, as it was indicated by the Freundlich isotherm model. The KF for the MIP with 25% of TiO2 was higher than for the materials with 5%; values for the MIP/TiO2 5% and the NIP/TiO2 5% KF were 4.808 and 4.163 (mg/g)(L/mg)1/n respectively, while for the MIP/TiO2 25% was 6.542 (mg/g)(L/mg)1/n and for the NIP/TiO2 25% it was 2.736 (mg/g)(L/mg)1/n. Kinetic studies followed the pseudo-second-order model, suggesting more active binding sites in MIPs. Photocatalytic experiments achieved 60% degradation, demonstrating the degradation performance of MIPs; however, this behavior is restricted by the slow degradation of NPX. The materials were evaluated using a water sample (Querétaro River, México); the sample was preconcentrated and analyzed, detecting a concentration of 0.332 mg/L of NPX. This finding highlights the MIPs’ potential application in environmental monitoring and treatment; nevertheless, due to the recalcitrant nature of NPX, MIPs should be used along with other advanced treatment methods to achieve effective removal.