Pitting corrosion of aluminium alloy AA5005-H34 immersed in natural sea water for up to 2 years is presented, together with new interpretations of the development of the pitting process over extended exposure periods. Trenching initiated at surface-located Fe-rich intermetallic (IM) particles. It occurred more extensively in sea water compared to atmospheric exposures. With increasing exposures, the pitting morphologies became more complex. Three types, i.e. hemispherical pits (Type 1), crystallographic pits (Type 2) and characteristic ‘petal’-like pits (Type 3), were observed after 12 months. It is suggested that the formation of Type 2 and Type 3 pits occurs at an advanced corrosion stage, and are associated with large Fe-rich IM particles near the metal surface. The influence of marine growth on pitting was negligible.
Novel observations of changes in pitting morphology of 6060 aluminum alloys immersed for periods of 3 y, 3.5 y, and 4 y in temperate seawater are reported. They indicate that the initiation and propagation of pitting involve several different mechanisms. These result in small (semi-) hemispherical pits, irregular polygonal-shaped larger pits, and also extremely large and deep pits with complex morphologies. Principally intergranular corrosion and crystallographic pitting were observed. It is proposed that the changing nature of the pit morphologies is associated with the accumulated corrosion products and, to a lesser extent, affected by the marine growth attached to the metal surface.
14 September 2020 in Corrosion Engineering, Science and Technology: The International Journal of Corrosion Processes and Corrosion Control
This paper reports pitting corrosion loss data of AA5005-H34 aluminium alloy immersed in natural seawater for up to 2 years. It is shown that the data for mass loss, maximum pit depth and the average value of 15 deepest pits as a function of exposure time are not closely consistent with the classical power-law function. Instead, the data show a greater affinity to the early part of a bi-modal trend. The uncertainty of the pit depth data was analysed using extreme value theory. The results are that scatter in the data sets increases with exposure time. This is considered to be the result of the pit depth data population being non-homogeneous, characterised by a mixture of deep pits with differing pitting morphologies. The results of this study suggest that longer-term data and homogeneous data population are likely to be more reliable for future corrosion loss prediction purposes.
Three WC-10Co-4Cr coatings with different WC grain sizes were prepared by high-velocity air-fuel (HVAF) spraying. The corrosion behaviors were systematically evaluated in 0.2 mol/L H2SO4 and 0.4 mol/L HNO3 solutions through immersion tests and electrochemical measurements. The results reveal that WC grain size governs coating microstructural integrity, mechanical properties, and corrosion resistance. Among the three coatings, the medium-grained (MG) coating exhibits an optimized balance between compact microstructure, high microhardness, superior fracture toughness, and the best corrosion resistance in both acidic environments. The coarse-grained (CG) coating exhibits the worst corrosion resistance owing to its wide grain boundaries and high porosity, while the fine-grained (FG) coating is similarly compromised by slightly higher porosity and residual stress-induced microcrack networks that facilitate electrolyte penetration. The corrosion proceeds via preferential dissolution of Co in the CoCr binder phase driven by micro-galvanic coupling with WC, followed by WC particle detachment and pit formation. In a 0.4 mol/L HNO3 solution, the strong oxidizing nature accelerates both binder dissolution and direct WC oxidation.