The ice sheet and subglacial geological environment in Antarctica have become the focus of scientific exploration. The development of Antarctic drilling technology will serve as a crucial safeguard for scientific exploration. However, the extremely ultra-low temperatures and intricate geological conditions present substantial obstacles for drilling operations in Antarctica, and the existing drilling fluid technology cannot satisfy the requirements of efficient and safe drilling. To ameliorate the wettability and rheology of ultra-low-temperature drilling fluids, a new amide material (HAS) was prepared using dodecylamine polyoxyethylene ether, azelaic acid, and N-ethylethylenediamine as raw materials. Experiments using infrared spectroscopy, nuclear magnetic hydrogen spectroscopy, and contact angle indicated that the target product was successfully synthesized. Performance evaluation showed that 2% HAS could achieve a yield point of 2.5 Pa for drilling fluid at −55 °C, and it also gave the fluid superior shear-thinning characteristics and a large thixotropic loop area. This indicated that HAS significantly enhanced the rheological properties of the drilling fluid, ensuring that it can carry cuttings and ice debris. In addition, 2% HAS could also increase the colloidal rate from 8% to more than 76% at −55 °C in different base oils. Meanwhile, the colloid rate was maintained above 92.4% when the density was 0.92~0.95 g/cm³. Mechanism studies showed that HAS increased the zeta potential and decreased the particle size of organoclay. At the same time, it changed the organoclay state from a clustered state to a uniformly dispersed state, and the particle size decreased. It was found that HAS formed a weak gel grid structure through interactions between polar groups, such as amide and imino groups with organoclays particles, thus improving the rheology and wettability of drilling fluid. In addition, HAS is an environmentally friendly high-performance material.

Hydraulic oscillator tools (HOTs) are effective solutions for mitigating excessive drag encountered during sliding drilling in horizontal wells. However, their field performance remains unpredictable due to theoretical limitations in modeling nonlinear friction behavior under axial vibration. To address this gap, a series of friction tests was conducted on sandstone–steel pairs under water-based mud lubrication. Experimental results demonstrate that steady-state sliding friction follows the velocity-dependent Dieterich–Ruina model, while vibration–sliding coupled friction is accurately described by the Dahl model. Integrating these findings, a comprehensive drillstring dynamic model was developed. The model was solved using an explicit central difference method and validated against field hook load data from Well XX-1, with prediction errors below 9%. Parametric studies further quantified HOT performance, revealing that excitation force amplitude and HOT placement significantly impact drag reduction, whereas vibration frequency exerts a relatively modest influence. Meanwhile, the effective propagation distance induced by the hydraulic oscillator is relatively limited, resulting in a drag reduction rate of no more than 30% even under optimal parameter conditions. This work establishes a validated theoretical framework for optimizing hydraulic oscillator parameters in horizontal drilling.