In recent years, elastocaloric cooling technology has been considered as one of the most promising alternatives to vapor compression technology. Given that elastocaloric technology is only in the early stages of development, a uniform method for evaluating the elastocaloric effect has not yet been established, and the thermodynamics of different elastocaloric cooling cycles have not yet been studied in detail. Therefore, the main goal of this work is to investigate these two important areas. Here, multiple thermodynamic cycles were studied, focusing on the parameters of the holding period of the cycle, which is essential for heat transfer between the elastocaloric material and the heat sink/source. The cycles were applied to commercially available superelastic thin-walled NiTi tubes under compressive loading and a thin NiTi wire under tensile loading. Isostress cycles with constant stress throughout the holding period, isostrain cycles with constant strain throughout the holding period and no-hold cycles (without a holding period) were studied across multiple stress/strain ranges. Based on the experimental results, a previously developed phenomenological model was applied to better understand and further evaluate the different cycles. The results revealed that the applied thermodynamic cycle significantly affects the thermomechanical response and thus the cooling/heating efficiency of the elastocaloric material. We show that by using isostress cycles and partial transformations, a Carnot-like thermodynamic cycle with improved heating/cooling efficiency can be generated. By applying the isostress cycles, an adiabatic temperature change of 30.2 K was measured, which is among the largest directly measured reproducible adiabatic temperature changes reported for any caloric material to date. Ultimately, this study intends to serve as a basis for establishing a uniform method for evaluating the elastocaloric effect in different materials that would allow for reliable and accurate one-to-one comparison of the reported results in the rapidly growing field of elastocalorics.
This study examines the potential of sustainable, biobased paper-based structures as panel/membrane sound absorbers. Although intact paper is naturally impermeable and a poor sound absorber, transforming it into complex three-dimensional origami geometries, specifically the Miura-ori pattern, could produce effective panel/membrane absorbers. Three distinct Miura-ori samples (A, B, and C) were fabricated with increasing geometric complexity, ranging from a simple triangular prism to a complex labyrinthine waveguide. The random incidence sound absorption coefficients of these samples were measured in a validated small-scale reverberation room. The underlying absorption mechanisms were further investigated through modal analysis and non-contact vibration velocity measurements. The results indicate that increased geometric complexity enhances acoustic performance. Sample C, the most complex structure, demonstrated the most consistent broadband absorption. The analysis confirmed a significant positive correlation between acoustic pressure modes, surface vibration velocity, and sound absorption peaks, indicating that acoustic energy dissipation is driven by the vibrational response of the paper membrane coupled with resonant modes in the air gap. This research demonstrates that tunable origami folding techniques using intact paper can be used to design lightweight acoustic treatments for diffuse sound fields in the mid-frequency range.