Erin Bobicki

Dr. Erin Bobicki

Department of Materials Science and Engineering, University of Toronto, Toronto, ON M5S, Canada

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
4 February 2019 in The Canadian Journal of Chemical Engineering
Verified
Journal Article
Closed access
PDF file
NCNestor Cruz
Nestor Cruz
JFJohn Forster
John Forster
Erin BobickiErin Bobicki
Erin Bobicki

1 November 2018 in Powder Technology
Verified
Journal Article
Closed access
JFJ. Forster
J. Forster
YMY. Maham
Y. Maham
Erin BobickiErin Bobicki
Erin Bobicki

11 November 2018 in Minerals
Verified
Journal Article
Open access
PDF file
Erin BobickiErin Bobicki
Erin Bobicki
QLQingxia Liu
Qingxia Liu
ZXZhenghe Xu
Zhenghe Xu
Ultramafic nickel ores are difficult to process because they contain serpentine, an anisotropic mineral with a nonspherical morphology and multiple pH-dependent surface charges. Dehydroxylation of serpentine in ultramafic nickel ores by microwave treatment is proposed to improve the processability of these ores. Upon heating, serpentine is converted to olivine, an isotropic mineral that is benign in mineral processing circuits. The microwave heating of two ultramafic nickel ores is explored in this paper, as well as effects on mineralogy and grindability. The first ore was sourced from the Okanogan nickel deposit in Washington State, USA, while the second ore was obtained from the Vale-owned Pipe deposit located in the Thomson Nickel Belt in Manitoba, Canada. The ultramafic nickel ores were found to heat well upon exposure to microwave radiation and the heating behaviors were a function of the imaginary permittivities. The temperatures achieved during microwave treatment were sufficient to dehydroxylate serpentine, and the serpentine content in ultramafic nickel ores was reduced by 63–84%. The grindability of ore with consistent texture (OK ore) improved dramatically with microwave treatment, whereas the grindability of ore with inconsistent texture (Pipe ore) was found to decrease. Pentlandite liberation and specific surface area improved for both ores with microwave treatment. Ultimately, microwave pretreatment did not decrease the energy required for grinding under the conditions studied. However, energy savings may be realized when overall process improvements are considered (e.g., grinding, rheology, flotation, material handling, dewatering and tailings treatment).

19 February 2021 in Faraday Discussions
Verified
Journal Article
Closed access
PDF file
SKShaihroz Khan
Shaihroz Khan
OWOmar Bashir Wani
Omar Bashir Wani
MSMohammad Shoaib
Mohammad Shoaib
JFJohn Forster
John Forster
RSRana N. Sodhi
Rana N. Sodhi
Erin BobickiErin Bobicki
Erin Bobicki
A proof-of-concept for the carbonation-assisted processing of ultramafic nickel ores is presented. Carbonation converts serpentine, the primary gangue or undesirable mineral, to magnesite. It prevents slime coating of fine gangue minerals on pentlandite, the main nickel-bearing mineral, during froth flotation, and improves nickel recovery and concentrate grade. Additionally, CO2 is captured and stored in the form of solid carbonates, thus removing it from the atmosphere. Microflotation experiments demonstrated improved nickel recovery (61.2 to 87.4 wt%) and concentrate grade (20.6 to 24.7 wt%) in carbonated vs. uncarbonated systems. The mechanism behind the improved nickel flotation was investigated by zeta potential measurements, optical imaging microscopy, X-ray photoelectron spectroscopy and time-of-flight secondary ion mass spectrometry. These analyses confirmed the absence of slime coating in the carbonated system under the flotation conditions tested. Finally, a preliminary techno-economic analysis was performed to evaluate the cost metrics of incorporating carbonation into nickel mineral processing.

29 January 2022 in Journal of Colloid and Interface Science
Verified
Journal Article
Closed access
NMNahid Molaei
Nahid Molaei
OWOmar Bashir Wani
Omar Bashir Wani
Erin BobickiErin Bobicki
Erin Bobicki

27 July 2021 in Soft Matter
Verified
Journal Article
Closed access
PDF file
MSMohammad Shoaib
Mohammad Shoaib
Erin BobickiErin Bobicki
Erin Bobicki
Kaolinite particles are geometrically anisometric and electrostatically anisotropic. Until recently, the charge of both basal faces of kaolinite was assumed to be independent of pH, and the isoelectric point (IEP) of the edge surface was thought to occur at pH 4–6. Therefore, kaolinite suspensions were expected to have an edge–face association at low pH. However, recent atomic force microscopy (AFM) studies have shown that the kaolinite alumina basal face and edge surface carry a pH-dependent surface charge with an IEP at pH 5–6 and ∼ 3, respectively. Here, we revisit the modes of particle association in kaolinite suspensions and apply Derjaguin–Landau–Verwey–Overbeek (DLVO) theory to study the rheological implications of surface charges of various kaolinite faces from recent AFM-based studies. Specifically, aging within the linear viscoelastic region, small amplitude oscillatory shear behavior (strain amplitude and frequency response), and critical stress behavior were studied as a function of pH. Kaolinite suspensions (40 wt%) exhibited two-step structure recovery after shear rejuvenation and two-step yielding at pH less than the IEP of the alumina basal face. In addition, the storage modulus (G′) and critical stress required to stabilize the flow followed non-monotonic behavior as a function of pH. At low pH, the silica face–alumina face mode of association was expected to be dominant rather than the edge–face microstructure. A peak in the G′ vs. pH curve at pH 4.5–5 was correlated with the silica face–alumina face attraction estimated from DLVO theory, which passes through a maximum at approximately the same pH. Based on these observations, we propose a qualitative state diagram for kaolinite suspensions in the pH-concentration space.