This study presents a sustainable waste-to-resource approach for water treatment through the development of an immobilized adsorption–photocatalytic system based on Fe-doped TiO2 and biomass-derived hard carbon. Hard carbon was synthesized from durian peel via a hydrothermal–carbonization process, transforming agricultural waste into a high-value adsorbent with a high specific surface area (279 m2 g−1) and hierarchical pore structure. Fe-doped TiO2 nanoparticles were prepared using a solution combustion method with titanium isopropoxide (TTIP) and glycine, resulting in porous anatase-dominant structures. The Fe-doped TiO2/hard carbon composite was subsequently coated onto 3D-printed polylactic acid (PLA) scaffolds to form an immobilized catalytic system. Structural and physicochemical characterization (X-ray diffraction (XRD), Rietveld refinement, scanning electron microscopy/transmission electron microscopy (SEM/TEM), Brunauer–Emmett–Teller (BET), ultraviolet–visible diffuse reflectance spectroscopy (UV–Vis DRS), and photoluminescence (PL)) confirmed that Fe doping effectively reduced the bandgap (from 3.02 to 2.89 eV) and introduced defect states that enhance charge separation. The 3 mol% Fe-doped TiO2 exhibited the most optimal structural and textural properties, including the highest surface area (123 m2 g−1) among TiO2-based samples. Photocatalytic performance was evaluated using methylene blue (MB) as a model organic pollutant. The Fe-doped TiO2/hard carbon-coated PLA structures demonstrated enhanced removal efficiency compared to pristine TiO2, attributed to a synergistic mechanism combining pollutant adsorption and photocatalytic degradation. The hard carbon component facilitates pollutant pre-concentration, while Fe doping improves light absorption and suppresses charge carrier recombination. The 3 mol% Fe-doped TiO2/hard carbon system exhibited the best performance, consistent with its optimized structural, optical, and surface properties. Importantly, the use of biomass-derived carbon and 3D-printed biodegradable PLA substrates highlights the environmental and practical advantages of the developed system, including resource recovery, catalyst stability, and ease of reuse. This work demonstrates a promising pathway for integrating waste valorization with advanced water treatment technologies, contributing to sustainable and circular approaches for environmental remediation.
The demand for eco-friendly photoprotection has increased due to the observed adverse effects of conventional UV filters on marine ecosystems. In this study, we developed a broad-spectrum, reef-friendly sunscreen emulsion containing Perilla frutescens seed extract. The extraction process was optimized using 95% ethanol maceration for one week, yielding the highest SPF of 22.61. Gas chromatography–mass spectrometry (GC-MS/MS) was used to identify linolenic acid (43.54%) as the predominant fatty acid. Cytotoxicity test results for HaCaT keratinocytes were used to confirm the extract’s safety, with an IC50 of 12.9 mg/mL. The formulated sunscreen met environmental safety standards based on persistence, bioaccumulation, and toxicity (PBT) criteria. A clinical safety evaluation using a 24 h closed patch test (n = 17) demonstrated that the formulation induced no significant alterations in TEWL or erythema levels (p > 0.05), confirming its dermatological safety. In a clinical efficacy evaluation involving 30 volunteers, the formulation containing 1% perilla extract reduced both erythema values and the melanin index, with no statistically significant difference observed (p > 0.05). These findings demonstrate that P. frutescens seed extract is a potent bioactive ingredient for sustainable cosmeceuticals, offering effective sun protection while ensuring safety for both human skin and marine environments.