A range of optical fibre-based sensors for the measurement of ethanol, primarily in aqueous solution, have been developed and are reviewed here. The sensing approaches can be classified into four groups according to the measurement techniques used, namely absorption (or absorbance), external interferometric, internal fibre grating and plasmonic sensing. The sensors within these groupings can be compared in terms of their characteristic performance indicators, which include sensitivity, resolution and measurement range. Here, particular attention is paid to the potential application areas of these sensors as ethanol production is globally viewed as an important industrial activity. Potential industrial applications are highlighted in the context of the emergence of the internet of things (IoT), which is driving widespread utilization of these sensors in the commercially significant industrial and medical sectors. The review concludes with a summary of the current status and future prospects of optical fibre ethanol sensors for industrial use.
The torsion measurement and torsion direction discrimination characteristics of a multimode fiber (MMF) geometry in a singlemode-multimode-singlemode (SMS) fiber structure are investigated theoretically and experimentally. Three different geometries of MMFs, including circular symmetric MMF, axisymmetric MMF, and asymmetric MMF were fabricated based on a fiber polishing technique. The torsion response characteristics of a MMF depends on the birefringence within the MMF, as birefringence is related to the twist rate of the fiber. The experimental results demonstrate that the unpolished MMF with a circular asymmetric refractive index (RI) distribution has no wavelength response to torsion, and the single-side polished MMF with an axisymmetric RI distribution can measure torsion, but it does not have the ability to discriminate torsion direction. It is found that an MMF section with two polished surfaces at an angle to each other results in a departure from the symmetrical RI distribution, which introduces elliptical birefringence into the MMF. As a result, directional torsion measurement is achieved with sensitivities of 0.162 nm/(rad/m) clockwise and −0.139 nm/(rad/m) counterclockwise. The MMF geometry presented provides a new approach to torsion direction discrimination and shows good application potential in practical torsion vector measurement.
10 September 2021 in Journal of Lightwave Technology
A novel optical sensor for ammonia concentration in water is demonstrated using up-conversion (UC) fluorescence intensity ratio (FIR). The sensor element consists of (i) an Er 3+ -Yb 3+ co-doped tellurite glass microsphere integrated inside a section of suspended tri-core hollow fiber (STCHF) and (ii) the pH indicator phenol red. When 980 nm pump is coupled into the microsphere, the Er 3+ ions produce green and red UC emissions. Exposure to ammonia results in a strong increase in the 560 nm absorption of the phenol red, which acts as a filter for the green emission, while the red emission is unaffected. A simple linear relation between the FIR and the ammonia aqueous concentration has been established.
A femtosecond (fs) laser fabricated refractive index (RI) modulated multimode fiber (MMF) for high sensitivity vector bending measurement is presented. A fs laser-induced local positive RI modulation in the MMF core results in a non-circular symmetric RI distribution of the MMF. Such a RI-modulated MMF used in single-mode-multimode-single-mode (SMS) fiber structure exhibits a bending-dependent spectral shift response. Due to the large core size of the MMF, the RI modulated area can be relatively far away from the fiber core axis, which in turn results in a greater effective RI change during bending. Experimental results show that the highest bending sensitivity of −45.8 nm/m −1 is achieved at 0° orientation with the resonant wavelength of 1554.4 nm. In addition to its high sensitivity and simple structure, this vector bending sensor exhibits ultra-low temperature crosstalk in bending measurements, as low as 0.0002 m −1 /°C, which makes it an excellent candidate for accurate vector bending monitoring applications.