In proton exchange membrane water electrolysis (PEMWE) cells the performance and thus the conversion efficiency are influenced by the interface between the porous transport layer (PTL) and the catalyst layer (CL). In the following paper, this interface is modified by the use of femtosecond laser-induced surface structuring, so that the specific surface area of the titanium based fibers of the PTL is increased. The resulting morphology exhibits two roughness levels of (i) a relatively coarse structure featuring tips of a few micrometers in diameter and depth, which are each covered in turn by (ii) a substructure of smaller tips of a few to several hundred nanometers in diameter and depth. PEMWE electrochemical characterization and short-term stress tests reveal that the cell performance is increased due to the laser-structuring of the PTL surface towards the CL. For instance, the cell voltage is reduced by approximately 30 mV after 100 h at 4 A cm−2. These beneficial effects are observed over the entire current density range and thus correspond to a decreased equivalent cell resistance of at least 6 mΩ cm2 for electrical interfacial contact losses and at least 2 mΩ cm2 for mass transport losses. A physical characterization by scanning electron microscopy shows that the CL surface is much rougher and more jagged when using laser-structured fibers. Thus, the gaseous oxygen and the liquid water transport both from and to the active sites of the catalyst seem to be improved.
25 May 2022 in International Journal of Hydrogen Energy
This paper analyzes the impact of femtosecond laser pulse irradiation on the crystallinity of silicon wafers by means of electron backscatter diffraction (EBSD) measurements. EBSD based image quality maps and orientation imaging microscopy maps are correlated to the grade of the silicon crystallinity. We analyze the impact of accumulated net laser irradiation originating from a laser spot overlap that is necessary to process macroscopic areas, e.g., for sulfur doping of semiconductor devices. Furthermore, we demonstrate that post processing annealing recovers crystallinity and therefore allows fs-laser processed silicon to be used in semiconductor device manufacturing.
Electrocatalytic hydrogenation (ECH) of biomass derived compounds is an emerging technology for the production of biofuels. Herein, the ECH of furfural was investigated systematically on femtosecond laser‐structured copper electrodes, amending the work on commonly used bulk copper electrodes or electrodeposits. Laser‐structuring was used to vary the amount of active sites and the crystallographic orientation on the copper electrodes (evidenced with scanning electron microscopy and X‐ray diffraction), and to achieve nickel alloying with the structured copper surface. We showed that the production rate and the Faradaic efficiency for furfural ECH on both Cu (111) and Ni‐alloyed Cu were substantially increased. This improvement was ascribed to more catalytic sites offered for hydrogen and interactions of furanic intermediates. Moreover, the Ni‐alloyed Cu electrode enabled the stable production of 2‐methylfuran even at large overpotentials. The mechanistic insights gained could open up new pathways to produce sustainable biofuel candidates with more stable electrodes.