The transition toward carbon-neutral energy systems has accelerated interest in hydrogen-fueled combustion technologies, where efficient fuel–air mixing is essential for stable and clean combustion. In the present study, the mixing characteristics of under-expanded supersonic jets injected into a pressurized environment are numerically investigated using validated computational fluid dynamics simulations. Two nozzle configurations are examined: a straight nozzle and sudden-expansion nozzles with different expansion ratios and expansion locations. The governing compressible flow equations are solved using the rhoCentralFoam solver with the SST k–ω turbulence model. The numerical framework is validated against Sod’s shock tube solution and experimental data for under-expanded supersonic free jets. The results show that sudden-expansion nozzles significantly modify the shock-wave structure, jet penetration, and lateral spreading compared with the straight nozzle. Among the investigated configurations, nozzles with intermediate expansion-section lengths exhibited pronounced Mach-disk oscillations with a dominant frequency of approximately 10 kHz. The normalized supersonic core length decreased from 17.79 for the straight nozzle to 5.50 for the best-performing sudden-expansion configuration, while the normalized jet half-width increased from 0.82 to 1.70, indicating substantially enhanced mixing performance. The findings demonstrate that nozzle geometry strongly governs the trade-off between flow stability and mixing enhancement in high-pressure supersonic jets.
Atmosphere-breathing Hall thrusters (ABHTs) have emerged as a promising propulsion technology for very low Earth orbit (VLEO) satellites because they can utilize residual atmospheric particles as propellant, reducing the need for onboard propellant storage. In this paper, the feasibility of an ABHT system was investigated through a combined experimental and numerical approach. Experimental tests using the THT-VI Hall thruster demonstrated stable operation with air propellant and achieved specific impulses up to 2847 s under high-voltage conditions, indicating the potential for atmospheric drag compensation. To evaluate the intake performance, Direct Simulation Monte Carlo (DSMC) simulations were conducted at an altitude of 180 km to examine the effects of intake geometry, including the duct aspect ratio and intake-to-thruster area ratio. The results showed that the intake system can generate discharge chamber pressures of approximately 10−3–10−1 Pa, which is sufficient for Hall thruster operation, but the maximum collected mass flow rate (0.298 mg/s) remained below the required 1.5 mg/s. Several modified intake configurations improved particle transport and reduced aerodynamic drag with the best design increasing mass flow rate by approximately 7.5 times compared with the baseline configuration. These findings indicate that the primary limitation of ABHT systems is the intake mass transport capability rather than the thruster performance itself. A further optimization of intake geometry and spacecraft integration is required to enable sustained VLEO operation.