With the global attention given to energy issues, the electrification of aviation and the development of more electric aircraft (MEA) have become important trends in the modern aviation industry. The electric actuator plays multiple roles in aircraft such as flight control, making it a crucial technology for MEA. Given the limited space available inside an aircraft, the power density of electric actuators has become a critical design factor. However, the pursuit of high power density results in the need for larger rated power and higher switching frequency, which can lead to severe electromagnetic interference (EMI) issues. This, in turn, poses significant challenges to the overall reliability of the electric actuator. This paper provides a comprehensive review of EMI in high power density motor drive systems for electric actuator systems. Firstly, the state of the art of electric actuator systems are surveyed, pointing out the contradictory relationship between high power density and EMI. Subsequently, various EMI modeling approaches of motor control systems are reviewed. Additionally, the main EMI suppression methods are summarized. Active EMI mitigation methods are emphasized in this paper due to their advantages of higher power density compared with passive EMI filters. Finally, the paper concludes by summarizing the EMI research in motor drive systems and offering the prospects of electric actuators.
Dynamic bipedal jumping is highly sensitive to takeoff momentum and landing configuration, making the direct execution of purely offline-optimized trajectories unreliable on full-sized humanoid robots in the presence of modeling inaccuracies and execution uncertainties. A key challenge is the gap between dynamic feasibility predicted offline using simplified models and executability on physical hardware, because such models cannot fully capture full-body dynamics, actuator behavior, contact transitions, and execution uncertainty. This paper proposes an offline-to-online planning and whole-body control framework for robust in-place jumping of full-sized humanoid robots. The framework integrates phase-consistent offline trajectory optimization, lightweight online reference reshaping, constraint-aware whole-body control, and actuator-level command mapping to improve execution robustness without online re-optimization. In the offline stage, centroidal-dynamics-based trajectory optimization generates jumping references subject to kinematic-consistency and contact-feasibility constraints. During execution, these references are adapted online using real-time state estimates to compensate for takeoff deviations and regulate the landing state; a weighted quadratic-programming whole-body controller then tracks the adapted references. Hardware experiments on a 79.5 kg humanoid robot demonstrate repeatable in-place vertical jumps with a height of approximately 30 cm and stable landings. The results show that robust jumping on a full-sized humanoid robot can be achieved by combining offline nominal trajectory generation with online execution adaptation rather than relying on exact reproduction of the offline trajectories.