In this study, the terahertz (THz) spectra of C3S were obtained in the 0.4–2.3 THz frequency range using different sample preparation methods. In the spectra, a sharp absorption peak of C3S was found at 2.03 THz. Under controlled conditions, the mass ratio of C3S was the most critical factor affecting the strength of the absorption peak, and the absorption coefficient followed the Beer–Lambert law, exhibiting a linear relationship with the mass ratio of C3S. The intrinsic dielectric constants of C3S and polyethylene (PE) were calculated in accordance with the Maxwell–Garnett (MG), Bruggeman (BM), and Landau–Lifshitz–Loovenga (LLL) models, using two-phase composite samples. The results show that the LLL model had the highest accuracy.
This study presents a systematic terahertz time-domain spectroscopy (THz-TDS) investigation of hardened cement paste, framed as a complex-optical measurement in which the real and imaginary parts of the response probe distinct microstructural attributes. Transmission-mode measurements were made on pastes with water-to-cement (w/c) ratios of 0.3, 0.4, and 0.5 at curing ages of 7, 14, 28, and 56 days. The effective refractive index, obtained from the time-domain pulse delay (7, 28, and 56 days, paired with mercury intrusion porosimetry), correlates strongly and linearly with porosity over nine porosity-paired conditions spanning 15.1–30.4% (pooled R2 = 0.94, p < 0.001). In a quasi-static effective-medium framework—where the pores a re far smaller than the THz wavelength—this reflects the dependence of the effective permittivity on the solid volume fraction: the Bruggeman model outperforms the Maxwell–Garnett model, and all data fall within the Wiener bounds, lying close to the upper bound, indicating a continuously connected solid matrix with isolated pores. Cross-validated porosity estimation is reliable to within about ±2 percentage points (refractive-index uncertainty ±0.02–0.04). The absorption follows a power law (β ≈ 1.0–1.3) characteristic of disorder-activated vibrational absorption, in which the loss of long-range order in the amorphous C–S–H relaxes the crystalline selection rules and couples the THz field to the full vibrational density of states. The refractive index (structure-sensitive, governed by volume fraction) and the absorption (material-sensitive, governed by solid disorder; estimated loss tangent of order 0.1) thus form two complementary channels. Combining the THz-derived porosity with the Powers hydration model gives a degree of hydration consistent with literature ranges—an indirect comparison rather than direct validation. These results establish THz-TDS as a non-contact, non-ionizing technique for rapid porosity estimation and hydration assessment of cementitious materials.