We have studied the effect of erbium‐impurity interactions on the 1.54 μm luminescence of Er3+ in crystalline Si. Float‐zone and Czochralski‐grown (100) oriented Si wafers were implanted with Er at a total dose of ∼1×1015/cm2. Some samples were also coimplanted with O, C, and F to realize uniform concentrations (up to 1020/cm3) of these impurities in the Er‐doped region. Samples were analyzed by photoluminescence spectroscopy (PL) and electron paramagnetic resonance (EPR). Deep‐level transient spectroscopy (DLTS) was also performed on p‐n diodes implanted with Er at a dose of 6×1011/cm2 and codoped with impurities at a constant concentration of 1×1018/cm3. It was found that impurity codoping reduces the temperature quenching of the PL yield and that this reduction is more marked when the impurity concentration is increased. An EPR spectrum of sharp, anisotropic, lines is obtained for the sample codoped with 1020 O/cm3 but no clear EPR signal is observed without this codoping. The spectrum for the magnetic field B parallel to the [100] direction is similar to that expected for Er3+ in an approximately octahedral crystal field. DLTS analyses confirmed the formation of new Er3+ sites in the presence of the codoping impurities. In particular, a reduction in the density of the deepest levels has been observed and an impurity+Er‐related level at ∼0.15 eV below the conduction band has been identified. This level is present in Er+O‐, Er+F‐, and Er+C‐doped Si samples while it is not observed in samples solely doped with Er or with the codoping impurity only. We suggest that this new level causes efficient excitation of Er through the recombination of e‐h pairs bound to this level. Temperature quenching is ascribed to the thermalization of bound electrons to the conduction band. We show that the attainment of well‐defined impurity‐related luminescent Er centers is responsible for both the luminescence enhancement at low temperatures and for the reduction of the temperature quenching of the luminescence. A quantitative model for the excitation and deexcitation processes of Er in Si is also proposed and shows good agreement with the experimental results.
We present a quantitative study of the evolution of point defects into clusters and extended defects in ion-implanted Si. Deep level transient spectroscopy (DLTS) measurements are used to identify and count the electrically active defects in the damaged region produced by Si ion implantation at energies of 145 keV–2 MeV, and fluences from to Analyses of silicon annealed in the temperature range 100–680 °C allow us to monitor the transition from simple point defects to defect clusters and extended defects that occur upon increasing the ion fluence and the annealing temperature. At low doses, only about 2% of the Frenkel pairs generated by the ion beam escape recombination and are stored into an equal number of interstitial and vacancy-type point defects. Thermal treatments produce a concomitant annealing of interstitial and vacancy-type defects until, at temperatures above 350 °C, only two to three interstitial-type defects per ion are left, and the DLTS spectra contain signatures of second-order point defects. Interstitial clusters at and are found to dominate the residual damage of silicon implanted at higher fluences, and at annealing temperatures, These interstitial clusters have point defect capture kinetics and are not observable in transmission electron microscopy (TEM), suggesting that they are smaller than ≈50 Å. Finally, for silicon implanted at higher Si doses, thermal treatments at 680 °C result in a strong decrease in the concentration of the interstitial cluster signatures and in the introduction of a different DLTS signal, which exhibits logarithmic rather than exponential carrier capture kinetics, a feature typical of an extended defect. Comparison of the formation and dissolution of this extended defect signature with TEM analyses indicates that this level is a signature of the rodlike {311} defects that are known to store the interstitials responsible for transient enhanced diffusion. These results suggest that the small interstitial clusters are either the precursors of the {311} defects or that they compete with {311} defects as sinks for self-interstitials.
In recent years thanks to the Internet of Things (IoT), the demand for the development of miniaturized and wearable sensors has skyrocketed. Among them, novel sensors for wearable medical devices are mostly needed. The aim of this review is to summarize the advancements in this field from current points of view, focusing on sensors embedded into textile fabrics. Indeed, they are portable, lightweight, and the best candidates for monitoring biometric parameters. The possibility of integrating chemical sensors into textiles has opened new markets in smart clothing. Many examples of these systems are represented by color-changing materials due to their capability of altering optical properties, including absorption, reflectance, and scattering, in response to different external stimuli (temperature, humidity, pH, or chemicals). With the goal of smart health monitoring, nanosized sol–gel precursors, bringing coupling agents into their chemical structure, were used to modify halochromic dyestuffs, both minimizing leaching from the treated surfaces and increasing photostability for the development of stimuli-responsive sensors. The literature about the sensing properties of functionalized halochromic azo dyestuffs applied to textile fabrics is reviewed to understand their potential for achieving remote monitoring of health parameters. Finally, challenges and future perspectives are discussed to envisage the developed strategies for the next generation of functionalized halochromic dyestuffs with biocompatible and real-time stimuli-responsive capabilities.
We have investigated the electronic properties of Er in crystalline Si using deep‐level transient spectroscopy and capacitance‐voltage measurements. Erbium was incorporated by ion implantation in a p+‐n junction structure. In order to explore the role of oxygen and defects some samples were coimplanted with O and the annealing behavior of the deep‐level spectra was explored in the temperature range 800–1000 °C for annealing times ranging from 5 s to 30 min. We show that O‐codoping produces large modifications in the Er‐related deep‐level spectra and, in particular, a promotion from deep to shallow levels, thus enhancing the donor behavior of Er in Si. For erbium implanted in pure crystalline Si the spectrum is dominated by deep levels arising from Er‐defect complexes which are easily dissociated upon thermal annealing. In O‐coimplanted samples the formation of Er‐O complexes with a characteristic level at EC−0.15 eV is observed. These complexes form upon thermal annealing and are stable up to 900 °C. These results are presented and possible implications for our current understanding of the mechanisms of Er photoluminescence in Si are discussed.