Hamed Samadi

Prof. Hamed Samadi


Research Focus & Metrics

Academic Career Length

22Years (2005-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 March 2012 in Journal of Thermal Spray Technology
Verified
Journal Article
Closed access
PDF file
HSHamidreza Salimijazi
Hamidreza Salimijazi
MHMehdi Hosseini
Mehdi Hosseini
JMJavad Mostaghimi
Javad Mostaghimi
LPLarry Pershin
Larry Pershin
TCThomas W. Coyle
Thomas W. Coyle
ASAli Shafyei
Ali Shafyei

24 September 2009 in Journal of Thermal Spray Technology
Verified
Journal Article
Closed access
PDF file
HSHamed Samadi
Hamed Samadi
TCT. W. Coyle
T. W. Coyle

11 April 2005 in SAE International Journal of Advances and Current Practices in Mobility
Verified
Conference Paper
Closed access
PDF file
RSR. Soltani
R. Soltani
HSHamed Samadi
Hamed Samadi
EGE. Garcia
E. Garcia
TCT. W. Coyle
T. W. Coyle
The use of thermal barrier coatings (TBCs) to increase the combustion temperature in diesel engines has been pursued for over 20 years. Increased combustion temperature can increase the efficiency of the engine, decrease the CO and (possibly) the NOx emission rate. However, TBCs have not yet met with wide success in diesel engine applications. The most common TBC system is Yttria Partially Stabilized Zirconia (Y-PSZ) which has shown good performance in turbine blade coatings where temperatures approach 1100°C. To reach the desirable temperature of 850-900°C in the combustion chamber from the current temperature of 350-400°C, a coating with a thickness of order 1mm is required, significantly thicker than turbine blade coatings which are on the order of 100μm thick. This results in different temperature and stress profiles in the coating during service than in the case of turbine coatings, and different failure mechanisms. Recent advances in the control of coating structure have led to the development of new PSZ coating microstructures containing grains and pores with sizes in the range of 100-300 nm. Thermal-mechanical properties of such coatings have been characterized and compared with coatings exhibiting the traditional thermal spray structure to asses their suitability as thick TBC for diesel engine applications. Selected coatings have been subjected to engine testing in an instrumented single cylinder diesel test rig. Among possible alternative materials, one of the most promising is mullite. Mullite has excellent thermo-mechanical behavior; however its low coefficient of thermal expansion creates a large mismatch with the substrate. To address this problem, multilayer systems have been developed which minimize the thermal expansion mismatch stresses while maintaining chemical and phase stability. The design considerations for such multilayer systems are discussed.

15 July 2010 in Surface and Coatings Technology
Verified
Journal Article
Closed access
HSHamed Samadi
Hamed Samadi
LPL. Pershin
L. Pershin
TCThomas William Coyle
Thomas William Coyle

25 May 2016 in JOM
Verified
Journal Article
Closed access
PDF file
SPS. N. Panahi
S. N. Panahi
HSHamed Samadi
Hamed Samadi
ANA. Nemati
A. Nemati

1 January 2006
Verified
Book Chapter
Closed access
PDF file
HSHamed Samadi
Hamed Samadi
TCT. W. Coyle
T. W. Coyle