Vibration monitoring is one of the most popular, effective, and reliable methods for bearing fault diagnosis. A key issue in the vibration monitoring for the bearings used in variable-speed wind turbines is the elimination of the effect of the turbine shaft speed fluctuation in the vibration signals measured under varying-rotating-speed conditions. This paper proposes a new current-aided vibration order tracking method for bearing fault diagnosis of variable-speed direct-drive (i.e., no gearbox) wind turbines. The method explores a new simple and effective approach to acquire the reference signal from a current signal measured from the stator of the generator for vibration order tracking. First, the instantaneous fundamental frequency of the current signal is estimated in the time-frequency domain to obtain the shaft rotating frequency. Then, the shaft phase-time relationship is established. With this information, the envelope of the synchronously recorded vibration signal is subsequently resampled at the equal-phase-increment time points. Finally, bearing fault diagnosis is performed by observing the peaks at bearing characteristic frequencies in the power spectrum of the resampled vibration envelope signal. The proposed method is validated by successful diagnosis of different bearing faults in a direct-drive wind turbine under varying-speed conditions.
Variational mode decomposition has been widely applied to machinery fault diagnosis during these years. However, it remains difficult to set proper hyperparameters for the variational mode decomposition, including number of decomposed modes, initial center frequencies, and balance parameter. Moreover, the low efficiency of the existing variational mode decomposition methods hinders their applications to practical diagnostic task. This article proposes an adaptive and efficient variational mode decomposition method after thoroughly investigating its convergence property characteristic. A convergent tendency phenomenon is discovered and is explained mathematically for the first time. Motivated by the convergent tendency phenomenon, the proposed method rapidly and adaptively determines the number and the optimal initial center frequencies of signal latent modes with the guidance of the convergent tendencies of the initial center frequencies changing from small to large. In the proposed method, the number of decomposed modes and initial center frequencies are not hyperparameters that require to be set in advance any more, but are parameters learned from the analyzed signals. The determined parameters enable efficient extraction of the main latent modes contained in the analyzed signals. Therefore, the proposed variational mode decomposition method represents a major improvement in parameter adaption and decomposition efficiency over the existing variational mode decomposition methods. In the application for bearing fault diagnosis, the faulty modes are selected adaptively and the corresponding balance parameters are further optimized efficiently. Two experimental cases validate the proposed method and its superiority over the existing variational mode decomposition methods and the classical fast spectral kurtosis in bearing fault diagnosis.
1 April 2012 in Mechanical Systems and Signal Processing