The ability to resist the effect of wind disturbance is vital for micro air vehicles. As the most compact rotor configuration for micro air vehicles, coaxial rotors will be the preferred choice for this type of devices. In this paper, the aerodynamic performance of the coaxial rotors considering the wind gust is presented with both experiments and simulations. First, effect of wind disturbances on the micro air vehicles flight was introduced. Then, low-speed wind tunnel tests were performed on a coaxial rotor with a spacing 0.39 R to obtain the performance in both horizontal and vertical wind of 0–5 m/s with the revolutions per minute ranging from 1500 to 2400. Finally, computational fluid dynamics simulations, as a means of visualizing the flow field to compensate the intuition of the experimental data, were applied by using the sliding mesh to capture the detailed interference of flow field with the distributions of streamline and velocity vector. Compared with wind tunnel tests, simulation results were highly consistent with experiments that allow to capture the flow details around the rotor tip effectively. In addition, the aerodynamic performance was deteriorated by vortices moving or deforming around the blade tip. Also, coaxial rotors can effectively resist the wind disturbance in the horizontal direction while the rotor performance was found to be declined in the vertical wind.
In order to study the aerodynamic performance of the quadrotor with different rotor spacings in hover, experiments were performed together with numerical simulations. For experimental study, an experimental platform was designed to measure the thrust and power consumption of the quadrotor with different rotor spacings (L/R = 2.2, 2.6, 3.0, 3.2, 3.6, and 4.0), and to attempt to find out the optimal rotor configuration which makes the quadrotor have the best aerodynamic performance. In addition, the pressure distribution, vorticity of the blade tip, and velocity vector of quadrotor in the flow field were obtained by Computational Fluid Dynamics (CFD) method to visually analyze the aerodynamic interference between adjacent rotors. By the comparison of experimental results and numerical simulations, the final results show that the aerodynamic performance of the quadrotor varies obviously with the change of rotor spacing, and it has a negative impact on hover efficiency if rotor spacing is too much small or large. The rotors pacing at L/R = 3.6 with larger thrust and smaller power is considered to be the best aerodynamic configuration for the quadrotor with better aerodynamic characteristics. Furthermore, compared with the isolated rotor, moderate aerodynamic interference is proved to help improve the aerodynamic performance of the quadrotor with a larger thrust, especially for a rotor spacing at L/R = 3.6.
In this paper, an attempt was made to obtain the aerodynamic performance of a Hex-rotor unmanned aerial vehicle with different rotor spacing. The hover efficiency of the Hex-rotor unmanned aerial vehicle is analyzed by both experimental tests and numerical simulations. First, a series of index to characterize the aerodynamic performance of the Hex-rotor unmanned aerial vehicle are analyzed theoretically, and then both tests and simulations on a Hex-rotor unmanned aerial vehicle with different rotor spacing ratio (i = 0.50, 0.56, 0.63, 0.71, 0.83) were presented in details. For a custom-designed test platform, the thrust, power loading and hover efficiency of the Hex-rotor unmanned aerial vehicle were obtained in this paper. Finally, computational fluid dynamics simulations are performed to obtain the streamline distributions of the flow field, pressure and velocity contour of the Hex-rotor unmanned aerial vehicle. Results show that the aerodynamic performance of the Hex-rotor unmanned aerial vehicle is varied by changing the rotor spacing. Specifically, the smaller rotor spacing may improve the aerodynamic performance of the Hex-rotor unmanned aerial vehicle by increasing the rotor interferences. In the meantime, the effects of mutual interference between the rotors are gradually reduced with the increase of the rotor spacing. Moreover, the uniformity of the streamline distribution, the shape and the symmetry of the vortex are necessary conditions for the Hex-rotor unmanned aerial vehicle to generate a larger thrust. It was also noted that the thrust increased by 5.61% and the overall efficiency increased by about 8.37% at i = 0.63 for the working mode (2200 r/min), which indicated that the rotor spacing ratio at i = 0.63 obtained a best aerodynamic performance.
The aerodynamic performance of the quadrotor is usually suffering a lower propulsive efficiency in a windy environment. Especially the horizontal wind may affect the attitude control to provide sufficient thrust to lift the entire vehicle or cause extra power consumption. In this paper, the aerodynamic characteristics of a micro quadrotor aircraft considering the horizontal wind disturbance are studied by both experiments and simulations. First, the aerodynamic model of the quadrotor with the influence of horizontal wind disturbance is deviated in details. Then, the distribution of flow field of the quadrotorr MAV considering the effects of horizontal wind was simulated by computational fluid dynamics (CFD) method. Finally, the thrust and power consumption of quadrotor with rotational speed ranged from 1500 to 2300 r/min were obtained in a low-speed wind tunnel. The comparison of simulation and experimental results shows that the distribution of flow field becomes more complicated with mutual interferences resulted by the distortion of rotor wake and crash of the downwash flow from the front rotors along with the wind direction. The thrust of the rotors gradually increases with wind speed, resulting from the increment of pressure difference between the upper and lower surfaces. However, the power consumption is also increasing because of the possible vibration caused by the strong interactions when the wind speed is up to 4.0 m/s. Also, the power loading of the quadrotor is larger at 2.5 m/s, which shows a good wind resistance with a better aerodynamic performance.
The coaxial Tri-rotor micro air vehicle (MAV) is composed of three coaxial rotors where the aerodynamic characteristics of is complicated in flight especially when the wind effect is introduced. In this paper, the hovering performance of a full-scale coaxial Tri-rotor MAV is analyzed with both the simulations and wind tunnel experiments. Firstly, the wind effect on the aerodynamic performance of coaxial Tri-rotor MAV is established with different rotor speed (1500–2300 rpm) and horizontal wind (0–4 m/s). Secondly, the thrust and power consumption of coaxial Tri-rotor (L/D = 1.6) were obtained with low-speed wind tunnel experiments. Furthermore, the streamline distribution, pressure distribution, velocity contour and vortex distribution with different horizontal wind conditions are obtained by numerical simulations. Finally, combining the experiment results and simulation results, it is noted that the horizontal wind may accelerate the aerodynamic coupling, which resulting in the greater thrust variation up to 9% of the coaxial Tri-rotor MAV at a lower rotor speed. Moreover, the aerodynamic performance is decreased with more power consumption at higher rotor speed where the wind and the downwash flow are interacted with each other. Compared with no wind flow, the shape of the downwash flow and the deformation of the vortex affect the power loading and figure of metric accordingly.
The mobility of a quadrotor UAV is significantly affected by its aerodynamics, especially when the closely spaced rotors are applied in the multi-rotor system. This paper addresses the aerodynamic modeling of non-planar quadrotor UAV with various rotor spacing (1 d–2 d) and disk plane angle (0–50 deg). The inter-rotor interference and the power models are also proposed in this paper. In order to validate the non-planar model, a series of CFD analyses and experiments were conducted. The obtained results demonstrate that the flow field of the non-planar quadrotor is extremely complicated when the unsteady flow is involved. The pulsation of partial angle of attack and pressure distribution is formed when the blade passes through the vortex. The thrust is increasing significantly along with the tilt angle, resulting from the stronger outflow of the non-planar rotors, which is also leading the power increment. However, the thrust increment is not that obvious when the spacing is larger than 1.4 d. The experiments and the numerical simulation results provide consistent trends and demonstrate the effectiveness of the aerodynamic model of the non-planar quadrotor. The comparison with the traditional planar quadrotor validates that the proposed non-planar quadrotor has better aerodynamic and control performances with a larger power loading.