The considerable energy waste in maritime transport and the need to obtain alternatives to reduce emissions of polluting gases are factors that have motivated the study of waste heat recovery systems for marine engines. The system studied herein relies on a binary vapor cycle that uses water for the topping cycle while three organic fluids were investigated for the bottoming cycle: R601a, R134a, and R22. Each of these belongs to a different category of fluid, namely, dry fluid, isentropic fluid, and wet fluid, respectively. Two engines of different ratings and two different pressures of the heat recovery steam generator have been considered for each engine. Various outlet pressures for the topping turbine, which is the most liable to erosion and corrosion due to wet steam, have been investigated. The maximum efficiency achieved for the waste heat recovery system peaked at 21% while the maximum electric power accounted for 4.2% of engine brake power. Therefore, the employment of a waste heat recovery system based on a binary cycle seems a promising alternative to harnessing heat from the exhaust gases of marine engines.

This study applies the Constructal Design method to the geometric optimization of a branched symmetric concentration divider for calibrating ultrasound devices used to monitor tumor response with dynamic contrast. Accurate calibration ensures image quality and diagnostic reliability. The geometry consists of a three-dimensional, tree-shaped flow network with two inlets and three outlets, where inlet 1 carries water containing contrast particles, while inlet 2 carries only water. Laminar flow simulations are performed using Computational Fluid Dynamics (CFD) with Ansys Fluent, assuming no-slip wall conditions and zero-pressure outlets. The analysis investigates the effects of the inlet velocity ratio, the diameter ratio, and the vertical positions of the central outlet and inlet tubes, while keeping the total volume and inlet diameter constant. Additionally, velocity, pressure, particle distributions, flow partition ratio, and hydraulic resistance are evaluated. Results show nearly linear concentration responses among the outlets (100%, 50%, and 0%) when the device approaches geometric symmetry with equal inlet velocities, demonstrating efficient control of flow splitting. Although the diameter ratio imposes a trade-off with hydraulic resistance, geometric symmetry combined with Constructal Design promotes improved flow uniformity and enhanced performance, with potential applications in microfluidic mixers that require precise intermediate concentrations.