The biomimicry of using a hair-like structure is introduced as a drag reduction coating. The hair-like structure consists of an array of microfiber that is introduced as a passive drag reduction device. An effective flow control for a transition delay or a flow attachment is expected via an interaction or counteraction of flexible fibers, compared to the existing passive methods that use a solid or rigid surface device. The effect of the microfiber coating on drag reduction over a bluff-body was experimentally investigated using a circular cylinder in a wind tunnel at Reynolds number of 6.1 × 10⁴. A drag reduction of 32% was obtained when the microfiber coating with a length of 0.012D was located at 40° from the stagnation point. Smoke flow visualization showed that flow separation delay was induced by the microfiber coating when the drag reduction occurred.

A hybrid anti-/de-icing system combining a superhydrophobic coating and an electrothermal heater is an area of active research for aircraft icing prevention. The heater increases the temperature of the interaction surface between impinging droplets and an aircraft surface. One scientific question that has not been studied in great detail is whether the temperatures of the droplet and the surface or the temperature difference between the two dominate the anti-/de-icing performance. Herein, this scientific question is experimentally studied based on the mobility of a water droplet over a superhydrophobic coating. The mobility is characterized by the sliding angle between the droplet and the coating surface. It was found that the temperature difference between the droplet and the coating surface has a higher impact on the sliding angle than their individual temperatures.

A microfiber coating having a hair-like structure is investigated as a passive flow control device of a bluff body. The effect of microfiber length is experimentally studied to understand the impact of the coating on drag on a cylinder. A series of microfiber coatings with different lengths are fabricated using flocking technology and applied to various locations over the cylinder surface under the constant Reynolds number of 6.1 × 10⁴ based on the diameter of the cylinder. It is found that the length and the location both play important roles in the drag reduction. Two types of drag reduction can be seen: (1) when the relative length of the microfiber, k/D, is less than 1.8%, and the coating is applied before flow separates over the cylinder; and (2) k/D is over 3.3%, and the coating is applied after the flow separation location on the cylinder. The maximum drag reduction for the former type is 59% compared to that from the cylinder without the microfiber coating. For the latter type, the maximum drag reduction is 27%.