The Main objective of this study was to identify source areas of soil erosion and quantify rate of soil erosion and sediment yield in Andassa watershed, Blue Nile Basin. In this study, Multi Criteria Decision analysis (MCDA) technique integrated with GIS and Remote sensing was applied to estimate soil erosion source areas, identify major soil erosion factor (s), prioritize and map the most sensitive soil erosion sources of the watershed for soil and water conservation practice. From soil erosion factors, Topographic wetness index followed by land use land cover have been found to have significant effect on soil erosion in the watershed. The result shows in qualitative Sensitivity map investigates that the more than half of the watershed was under moderately sensitive risk of soil erosion (68.12%) about 400.861km2. Next 17.56% (103.35km2) of the watershed was under slightly sensitive and the remaining 14.27% (83.999 km2) of the watershed was under highly sensitive risk of soil erosions. From the overall combined map of Multicriteria decision analysis (MCDA) map showing the areas of increased risk erosion represented by highly sensitive (S1), moderately sensitive(S2), less sensitive(S3), and constraint areas so the governmental or non-governmental organizations or any concerned organization should refer this important severity map of soil erosion for watershed management and priority of the watershed. Even though measured values of sediment yield at the catchment are hardly available the hotspot areas can be identified by multicriteria decision analysis and significant amount of soil loses are sourced from Gully sites.
The goal of this research was to enhance the current understanding of the interaction of surface water-ground water and impact assessment using a numerical model. Initially, to measure the natural recharge of the aquifer and to model streamflow, the surface water hydrology of the sub basin was researched using the HEC-HMS (SMA)model. The ground flow mechanism was analyzed by using 3D numerical groundwater flow model (Processing Modflow Pro (Version 5.3.0.1)). The HEC-HMS(SMA) model was used to measure the recharge rate for the sub-basin in order to achieve a recharge. Model calibration was subsequently carried out using the process of trial-and-error calibration using groundwater contours formed from heads collected at 56 observation points. Therefore, the average RMSE for simulated hydraulic heads was approximately 20. 65m.Simulated water levels in the model were more sensitive to decreases in recharge values and sensitive to decreases in hydraulic conductivity values. However, relative to recharge and hydraulic conductivity, the model is not as sensitive to decreases or increases in pump age. According to the simulation Lakes and rivers are significant sources of aquifer recharge. Finally, the model's water budget results showed that groundwater recharge comprised 81.48%, through river leakage 3.28% and constant head was 15.24% of the total water input for the entire study region. Because of this, it can be noted that the surface water impacts to the water budget of the sub-basin.
24 October 2025 in Modeling Earth Systems and Environment