For 6 × 4 dual-drive-axle battery electric tractors subject to intermediate-axle wheel-speed signal loss, the drive-wheel slip state is difficult to determine under adhesion-limited driving conditions, which can readily lead to drive torque distribution mismatch between the intermediate and rear axles and excessive slip of the intermediate-axle drive wheels. To address the above problems, this paper proposes a torque coordination control method for dual-drive-axle battery electric commercial vehicles. First, a drive-axle slip ratio is constructed based on the motor speed of the drive axle to enable axle-level characterization of the drive-axle slip state under wheel-speed signal loss. Second, the drive-axle slip state is identified using the local variation relationship between the ground driving force and the drive-axle slip ratio, and the reference slip ratio of the drive axle and the wheel-end transmissible torque limit are determined. Then, a hierarchical torque coordination control method is established. In the upper layer, with convergence of the drive-axle slip ratios of the intermediate and rear axles as the objective, the wheel-end transmissible torque limit is introduced for inter-axle drive torque distribution and constraint handling. In the lower layer, super-twisting sliding mode control is employed to perform anti-slip correction on the target torque of the drive axle. Finally, the proposed method is validated in a TruckSim/Simulink co-simulation environment. The results show that, under drive-wheel speed signal loss, the proposed method can achieve reasonable drive torque distribution between the intermediate and rear axles under adhesion-limited driving conditions, suppress excessive slip of the drive axles, and improve the smoothness of the vehicle longitudinal response.