We newly propose and experimentally demonstrate a differential measurement scheme for Brillouin optical correlation domain analysis, where the difference between Brillouin gain spectra constructed by a normal and a phase-modulated Brillouin pump waves are analyzed to measure local Brillouin frequencies in optical fibers. In experiments, a five-fold enhancement in the spatial resolution is obtained compared to an ordinary BOCDA system under the same modulation parameters, as a result of the improved dynamic range by the suppression of background noises.
24 October 2018 in Journal of Lightwave Technology
A theoretical model to describe in-band pumped holmium doped silica fiber lasers is presented. The model is established based upon theory and parameters obtained from published research works. Both core-pumped system and cladding-pumped system are simulated with the model. The simulation results agree well with most experimental results, and for the cases in which the simulation results show discrepancy with the experimental results the disagreement can be reasonably explained. Through numerical analysis it is found that besides common negative factors such as non-radiative decay, fiber loss, and non-optimized resonator configuration, energy transfer upconversion plays a deleterious role in the performance of in-band pumped holmium doped silica fiber lasers. In particular, inhomogeneous upconversion associated with ion clustering is found to cause significant degradation of slope efficiencies of lasers, a fact that is useful to understand the unsolved problem regarding the lower-than-expected slope efficiencies observed in previous studies of in-band pumped holmium doped fiber lasers.
We demonstrate an all-fiber Tm-doped soliton laser with high power by using a monolayer graphene saturable absorber (SA). Large area, uniform monolayer graphene was transferred to the surface of the side-polished fiber (SPF) to realize an in-line graphene SA that operates around 2 μm wavelength. To increase the nonlinear interaction with graphene, we applied an over-cladding onto the SPF, where enhanced optical absorption at monolayer graphene was observed. All-fiber Tm-doped mode-locked laser was built including our in-line graphene SA, which stably delivered the soliton pulses with 773 fs pulse duration. The measured 3-dB spectral bandwidth was 5.14 nm at the wavelength of 1910 nm. We obtained the maximum average output power of 115 mW at a repetition rate of 19.31 MHz. Corresponding pulse energy was estimated to be 6 nJ, which is the highest value among all-fiber Tm-doped soliton oscillators using carbon-material-based SAs.
8 September 2017 in Journal of Lightwave Technology
We propose and experimentally demonstrate a Brillouin optical correlation domain analysis (BOCDA) system adopting time-domain data processing and differential measurement for simultaneous interrogation of multiple sensing points. Continuous probe and pulsed pump waves are simultaneously frequency-modulated by a MHz-order sinusoidal RF wave so that multiple correlation peaks are sequentially generated according to the propagation of the pump along a fiber under test (FUT). The Brillouin gain spectrum (BGS) of each correlation peak is obtained and interrogated by moving window averaging of the probe wave with a span of the period of the RF modulation, leading to the simultaneous monitoring of the multiple sensing points. In experiments, 148 correlation peaks are concurrently interrogated with a spatial resolution less than 3 cm along a 1,530 m FUT.
We experimentally demonstrate a linearly configured Brillouin optical correlation domain analysis (BOCDA) system enhanced by a differential measurement scheme. On-off control of the pump phase modulation with an intentional loss at the end of a fiber under test is applied for the acquisition of a Brillouin gain spectrum. This application leads to a four-fold enhancement of the spatial resolution and doubling of the measurement range in comparison with the former system under the same modulation parameters.
The effects of ion clustering and excited state absorption occurring in holmium-doped fiber lasers are investigated experimentally and theoretically. It is found that the slope efficiencies of holmium-doped fiber lasers are reduced by inhomogeneous upconversion associated with the clustering of Ho3+ ions. Via theoretical analysis based upon Judd–Ofelt theory, it is also found that the effect of excited state absorption on the performance of Ho-doped fiber lasers is negligible, a fact indicating that ion clustering is the dominant cause of the lower-than-expected slope efficiencies observed in holmium-doped fiber lasers. We argue that ion clustering is an intrinsic flaw of holmium-doped fibers and is difficult to eliminate, because our research efforts are based on commercially available low-concentration fiber, which is fabricated with state-of-the-art techniques.