Herein, a superhydrophobic coating with high transparency and ultrahigh adhesive force was designed and prepared for use on the glass covers of solar cells, which exhibited excellent thermal stability and strong acid–base corrosion resistance. SiO2, as the bottom layer, was prepared via plasma enhanced chemical vapor deposition (PECVD), and then glycidoxypropyltrimethoxysilane (KH560) hydrolysis condensation resulted in the formation of hydroxyl groups at the two ends, which were used to form a network structure as the middle connecting layer. The top superhydrophobic layer was obtained via the hydrophilic modification of SiO2 by hexamethyldisilazane (HMDS). The structure of this superhydrophobic surface is similar to the bilayer structure of the phospholipids in the cell membrane. The superhydrophobic coating exhibited high optical transmittance, which reached 94% in the visible region. The results show that the superhydrophobic coating has an excellent self-cleaning performance (WCA = 153°). Moreover, its surface showed remarkable stability against strong acid, strong alkali, and the impact of water drops and sand. Finally, a simple simulation of silicon-based superhydrophobic glass solar cells was carried out, and a long-term outdoor experiment was performed to test their photoelectric conversion efficiency. During the two-month study period, the power conversion efficiency (PCE) of the solar cell module without the coating was reduced to 13.01% due to the natural deposition of dust, which was significantly lower than that of the superhydrophobic coating-covered module with self-cleaning function (PCE was 14.21%).
In recent years, people have paid increasing attention to improving the durability of highly transparent superhydrophobic surfaces. In this work, we first synthesized a superhydrophobic silica powder by using a one-step sol–gel method and then compounded it with Polydimethylsiloxane. After spin-coating on the glass surface, a transparent superhydrophobic glass with a high water contact angle (158°) was acquired. In the visible region (400–800 nm), the transmittance of the coated glass substrate was higher than 80%. Moreover, the obtained coating can maintain stable superhydrophobicity after undergoing treatment from −15 to 450°C and under extreme environmental conditions, such as strong acidity and alkalinity. In addition, the coating can maintain excellent superhydrophobicity even after exposure to a large amount of water flow impact.
Methylammonium iodide bismuthate ((CH3NH3)3Bi2I9) (MBI) perovskite was introduced as a new lead-free and air-stable absorber for hole conductor-free perovskite solar cells.
The overall objective of this research was the preparation of optical nanocomposite photoanodes through a simple method. The synthesized nanocomposite photoanodes were then used to improve the power conversion efficiency of dye-sensitized solar cells (DSSCs). Titanium dioxide (TiO2) nanofibers (NF) were prepared via electrospinning and calcination. Then, thin films were prepared with commercial TiO2 (NP) as a binder. Different concentrations of zinc oxide (ZnO) nanoparticles were used to impregnate TiO2 NP/NF. When the prepared nanostructures were used as photoanodes, the DSSCs based on NP/NF–ZnO film with an optimum concentration of ZnO (3.5 M) exhibited the highest short circuit current density (Jsc) of 12.83 mA cm−2 and open circuit voltage (Voc) of 0.764 V. The NP/NF–ZnO photoanode also exhibited a maximum power conversion efficiency (PCE) of 6.54%, which was higher by 26.5% than that of NP/NF (5.17%) with the same electrolyte.