In order to meet the high-power source requirement of compact submillimeter-wave systems, a high-power G-band extended interaction klystron (EIK) has been developed at the Aerospace Information Research Institute, Chinese Academy of Sciences (AIRCAS), and reported for the first time. The extended interaction circuit design based on over-synchronous voltage and high quality factor is proposed to enhance the output power and gain. In this manner, the designed EIK has achieved excellent test results compared with the same type of compact devices. Driven by a 20.3 kV, 198 mA pencil electron beam, the EIK can deliver a pulsed output power greater than 120 watts at around 0.22 THz, corresponding to a gain of 32 dB with a 5% duty cycle, and the average power and -1 dB bandwidth are 6 watts and 180 MHz respectively. Constrained by an axial magnetic field of about 1.03 T, the beam transmission is around 92% in RF operation.
29 May 2025 in IEEE Transactions on Plasma Science
This article proposes a novel double-corrugated waveguide with grating (DCWG) slow wave structure (SWS) for the development of a broadband high-power terahertz (THz) back-wave oscillator (BWO). By analyzing the electromagnetic properties, it is found that this SWS is suitable for interaction with a circular electron beam, with high interaction impedance and large “cold” bandwidth. In addition, particle-in-cell (PIC) simulation results indicate that the BWO based on the DCWG SWS can generate an output power exceeding 39.5 W in the frequency range of 327.4–362.2 GHz when the electron beam voltage is between 17 and 26 kV. In particular, at a voltage of 19.5 kV, the output power of the BWO can reach 52 W at a typical operating frequency of 0.34 THz. Therefore, this device has significant potential as a broadband, high-power THz radiation source.
19 May 2023 in IEEE Transactions on Electron Devices
An RF design of biperiodic multimode interaction circuit for $\textit{G}$ -band extended interaction klystron (EIK) is presented to overcome the bandwidth limitation of conventional EIK operating in a single mode. The $\pi $ -mode and its adjacent ladder mode are chosen as the operating modes of the input and output cavities. The effect of beam loading and the presence of the waveguide port on the cavity characteristics of the output cavity operating in the multiple modes are investigated, including the coupling coefficients, the frequencies, and the hot quality factors. The bandwidth of the gain section is broadened by the staggered tuning method. The 3-D particle-in-cell (PIC) simulation predicts a constant drive bandwidth of 4.5 GHz (exceeding 2% relative bandwidth) for the designed power amplifier around 220 GHz. Driven by a 21.4-kV, 0.25-A pencil electron beam, the amplifier can provide an output power of 195 W when the input power is 70 mW. The corresponding gain and electronic efficiency are 34.5 dB and 3.6%, respectively.
This paper proposes a double-corrugated waveguide with wide grating (DCWWG) slow-wave structure and applies it to the design of a low-voltage terahertz traveling-wave tube (TWT). To improve the TWT’s efficiency, a phase-tapered slow-wave structure is proposed. A response surface model is developed to identify the optimal tapering scheme, which is then further optimized using a genetic algorithm. Within the frequency range of 205–235 GHz, the phase-tapered DCWWG TWT exhibits significantly higher saturated output power and gain compared to the uniform DCWWG TWT. The maximum output power of the phase-tapered DCWWG TWT reaches approximately 26 W, representing an increase of about 47% over the 19 W maximum output power of the uniform DCWWG TWT. Overall, the phase taper technique substantially enhances the output performance of the DCWWG TWT.