Purpose: The purpose of this paper is to analyze the current state of the art manufacturing techniques using sand molds for the casting industry by the means of additive manufacturing (AM). In particular, this review will cover two families of 3D printing in regards to sand mold fabrication. Design/methodology/approach: This paper will discuss the sand casting manufacturing processes of AM by binder jetting (3D printing) and selective laser sintering. Scientific articles, patents and case studies are analyzed. Topics ranging from the technology types to the economic implications are covered. Findings: The review investigates new factors and methods for mold design, looking at mechanical properties and cost analysis as influenced by material selection, thermal characteristics, topological optimization and manufacturing procedure. Findings in this study suggest that this topic lacks vigorous scientific research and that the case studies by manufacturers thus far are not useful. Research limitations/implications: As demonstrated by the limited data from previous published studies, a more comprehensive and conclusive analysis is needed due to the lack of interest and resources regarding the AM of sand molds. Practical implications: This study is a useful tool for any researchers with an interest in the field of AM of sand molds. Social implications: Key perspectives are proposed. Originality/value: This review highlights current gaps in this field. The review goes beyond the scientific articles by curating patents and professional case studies.
Metal additive manufacturing based on Fused Filament Fabrication (FFF) of metal-filled polymers is emerging as a cost-effective alternative to conventional processes such as Metal Injection Molding (MIM), but its industrial relevance remains limited by challenges in densification and mechanical performance. This study presents an exploratory investigation of a low-cost FFF process using 316L stainless steel filament for industrial applications in railway maintenance. A Taguchi L8 design was employed as a screening approach to evaluate the influence of key printing parameters, followed by sintering using both internal and external configurations. The mechanical response depended strongly on sintering temperature: sintering at 1350 °C increased the ultimate tensile strength to 216–278 MPa and Young’s modulus to 63–109 GPa, while the apparent porosity remained between 12.6% and 16.9%. In the exploratory main-effects analysis of variance (ANOVA), none of the investigated printing parameters had a statistically significant effect on the measured responses (p > 0.05). For porosity at 1350 °C, nozzle diameter nevertheless showed the largest descriptive contribution (23.81%, F = 2.06, p = 0.2241). Overall, porosity introduced during the printing stage remained a major limitation of the process. Although the achieved properties remain below those of conventionally processed 316L, the process demonstrates potential for non-structural and cost-sensitive applications. Because each factor combination was tested once, the ANOVA and signal-to-noise (S/N) results are interpreted as exploratory screening and response ranking rather than confirmatory inference or independent evidence of robustness.