Jürgen Loipersböck

Mr. Jürgen Loipersböck

orcid

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 June 2017 in Korean Journal of Chemical Engineering
Verified
Journal Article
Open access
PDF file
JLJürgen Loipersböck
Jürgen Loipersböck
MLMarco Lenzi
Marco Lenzi
Reinhard RauchReinhard Rauch
Reinhard Rauch
HHHermann Hofbauer
Hermann Hofbauer
Most of the hydrogen produced is derived from fossil fuels. Bioenergy2020+ and TU Wien have been working on hydrogen production from biomass since 2009. A pilot plant for hydrogen production from lignocellulosic feedstock was installed onsite using a fluidized bed biomass gasifier in Güssing, Austria. In this work, the behavior of impurities over the gas conditioning stage was investigated. Stable CO conversion and hydration of sulfur components could be observed. Ammonia, benzene, toluene, xylene (BTX) and sulfur reduction could be measured after the biodiesel scrubber. The results show the possibility of using a commercial Fe/Cr-based CO shift catalyst in impurity-rich gas applications. In addition to hydrogen production, the gas treatment setup seems to also be a promising method for adjusting the H2 to CO ratio for synthesis gas applications.

11 December 2018 in Chemengineering
Verified
Journal Article
Open access
PDF file
JLJürgen Loipersböck
Jürgen Loipersböck
MLMarkus Luisser
Markus Luisser
SMStefan Müller
Stefan Müller
HHHermann Hofbauer
Hermann Hofbauer
Reinhard RauchReinhard Rauch
Reinhard Rauch
The worldwide production of hydrogen in 2010 was estimated to be approximately 50 Mt/a, mostly based on fossil fuels. By using lignocellulosic feedstock, an environmentally friendly hydrogen production route can be established. A flow sheet simulation for a biomass based hydrogen production plant was published in a previous work. The plant layout consisted of a dual fluidized bed gasifier including a gas cooler and a dust filter. Subsequently, a water gas shift plant was installed to enhance the hydrogen yield and a biodiesel scrubber was used to remove tars and water from the syngas. CO2 was removed and the gas was compressed to separate hydrogen in a pressure swing adsorption. A steam reformer was used to reform the hydrocarbon-rich tail gas of the pressure swing adsorption and increase the hydrogen yield. Based on this work, a research facility was erected and the results were validated. These results were used to upscale the research plant to a 10 MW fuel feed scale. A validation of the system showed a chemical efficiency of the system of 60% and an overall efficiency of 55%, which indicates the high potential of this technology.

14 September 2020 in Biomass Conversion and Biorefinery
Verified
Journal Article
Closed access
PDF file
JLJürgen Loipersböck
Jürgen Loipersböck
GWGerald Weber
Gerald Weber
Reinhard RauchReinhard Rauch
Reinhard Rauch
HHH. Hofbauer
H. Hofbauer

28 December 2020 in Catalysis Science & Technology
Verified
Journal Article
Closed access
PDF file
MLMorten Logemann
Morten Logemann
PWPatrick Wolf
Patrick Wolf
JLJürgen Loipersböck
Jürgen Loipersböck
ASAlexander Schrade
Alexander Schrade
MWMatthias Wessling
Matthias Wessling
MHMarco Haumann
Marco Haumann
Supported ionic liquid-phase (SILP) catalyzed water–gas shift reaction with in situ product removal is presented. A facilitated transport membrane coated onto the smooth outside of the SiC monolith allowed preferential removal of CO 2 compared to H 2 .