Pulsed dc magnetron reactive sputtering of dielectrics provides a deposition process without arcing. The deposition process is usually carried out with pulsing frequencies in the range 10-350 kHz and duty cycles in the range 50-90%. The operating conditions are typically optimized empirically and are critically dependent on the properties of the pulsed plasma in the immediate vicinity of the magnetron. We show how a combination of time-resolved Langmuir probe measurements and time-resolved optical emission spectroscopy can be used to characterize the pulsed magnetron plasma and gain insights that can only be obtained conclusively by correlating the results obtained by both techniques. The pulsed dc sputtering of Al and Ti targets and the reactive sputtering of their oxides were used as examples in our experiments. Our experiments were carried out at total pressures in the range 0.4-1.3 Pa in either pure Ar ('metallic' mode) or in Ar-O 2 mixtures ('oxide' or 'reactive' mode) with mixing ratios from 1 : 1 to 1 : 4.
3 April 2009 in IEEE Transactions on Plasma Science
In large-scale ozone generators for industrial or public utilities applications, low-power consumption, robustness of operation, and minimum maintenance requirements are of the highest importance. In order to meet these operational parameters, this paper explores the possibility to use inhomogeneous feed gas processing in a new generation of large-scale ozone generators. We utilize a finite-element model to simulate a discontinuous power induction along the length of the ozone generator tube. The simulation yields the local power density, the local gas temperature gradient, and a relative dielectric barrier discharge (DBD) filamentation packing density. This information, in conjunction with experimental data, provides a sufficiently broad basis of information to infer a correlation between the electrode arrangement and the ozone generation efficiency and overall ozonizer performance. Several ozonizer configurations were designed, simulated, manufactured, tested, and their performance was assessed. This led to a new design for large-scale ozone generators with the possibility of increasing ozone formation efficiency through the tailoring of the DBD microdischarges or microplasmas. The new arrangement tolerates a higher power induction at the inlet of the ozonizer, which has several advantages over constant power induction arrangements. The degree of DBD filamentation emerges as the decisive factor that enables the tailoring of the plasma. Evidence of an increased O3 generation efficiency and significantly reduced electrical power consumption are shown on an industrial-scale ozonizer with more than 100 m2 of active DBD microplasma area.
1 February 2003 in International Journal of Mass Spectrometry