The amount of released water (discharge) in a levee breach is a primary input variable to establish an emergency action plan for the area next to the levee. However, although several studies have been conducted, there is still no widely applicable discharge coefficient formula; this needs to be known to estimate discharge amount through an opening caused by a levee breach. Sometimes, the discharge coefficient developed for a sharp crested side weir is used to rate the discharge, but, in case of a levee breach, the resulting geometry and flow types are similar to that over a broad crested weir. Thus, in this study, two different openings—rectangular and trapezoidal shape—are constructed in the center of a levee at a height of 0.6m to replicate levee breach scenarios, and the effect of two different approach flow types—the river type approach and reservoir type approach—are explored to suggest a discharge coefficient formula applicable for discharge rating for a levee breach. The results show that the ratio of head above the bottom of an opening and the opening width is a key variable for calculating the discharge coefficient of a reservoir type, but the approach Froude number should also be considered for a river type approach. The measured data are used to improve rating equations and will be useful in the future to validate computational fluid dynamics simulations of wave propagation during levee failure into the inundation area.
Shear stress is the resistance force on top of the contact surface caused by moving flow and is one of the important variable in fluid mechanics. Thus, a lot of researches have been conducted to predict accurate value of shear stress. However, calculating shear stress with existing equations has several limitations because only gradually varied flow and/or uniform flow was considered in their studies. Therefore, direct applying those methods into complex flow type, such as around a bridge, to predict shear stress is questionable. Thus, laboratory experiments were carried out in a laboratory flume to attack the objective of this research which is “analyzing shear stress in the complex flow field”. The complex flow was made by construction of flow constriction structure in one side of flume, and the effect of three-dimensional flow around the constriction structure and back-water effect at the approach section of the structure were replicated in the flume. Water depth, velocity, and turbulence characteristics were measured by ADV and the measurements were used as input variables for various shear stress formulas. Total seven shear stress formulas are used in the analysis. As a result of this study, the appropriate shear stress formulas are suggested to calculate bed shear stress in the approach section and bed shear stress characteristic is shown with respect to flow constriction.