Despite its long history, a double-concave (DC) Fabry-Perot open resonator (FPOR) has recently gained popularity in the characterization of dielectrics in the 20–110 GHz range, mainly due to such novel accomplishments as full automation of the measurement process and the development of even more accurate and computationally efficient electromagnetic model. However, it has been discovered that such a DC resonator suffers from unwanted mode coupling present for electrically thick samples. Such limitations are missing in a plano-concave (PC) FPOR. For those reasons, the aim in this article is to apply the newly proposed scattering matrix method in the study of major properties of that kind of a resonator and, subsequently, to propose a new tool dedicated to the measurement of dielectrics without the aforementioned limits. For the first time in the literature, major properties of the PC FPOR with and without the sample, such as resonance frequencies, geometric factors, energy filling factors, and the resulting quality factor, are rigorously computed. Moreover, their impact on the accuracy of the loss tangent extraction is investigated. Such a study, which opens the way for accurate microwave characterization of electrically thick dielectric sheets above 20 GHz, has never been performed before. The whole complex permittivity extraction algorithm presented in this article is validated experimentally by measuring well-known materials, namely, C-plane sapphire, silicon, and Z-cut monocrystalline quartz.
A new method dedicated to the measurement of the moisture content and salinity of soil is proposed in this paper. The method takes the advantage of the most accurate permittivity sensor available at microwave frequencies based on a ${\mathrm {TE}}_{01\delta }$ mode dielectric resonator providing the effective complex permittivity of the measured mixture. The measurement has been undertaken mostly at 1 GHz due to the fact that conductive losses of liquids are substantially varying with salinity at low microwaves, thus, increasing measurement sensitivity. At first, intrinsic properties of the major components of the soil, such as sand, salt and saline water, are extracted from the effective parameters measured at microwave frequencies and compared with the Maxwell-Garnett mixing rule to extract their intrinsic properties. In case of the soil, the unknown moisture content and salinity are extracted from raw measurement results using an empirical permittivity model of a conductive mixture which, unlike to analytical dielectric mixing rules, accounts for a percolation threshold.
A Fabry-Perot open resonator (FPOR) is a tool dedicated to broadband accurate microwave and millimeter-wave characterization of dielectric sheets. Despite the various advantages of that method, one of the major challenges limiting its applicability is unintentional coupling of Gaussian modes of interest with a particular family of parasitic higher order modes. The coupling affects the resonance frequency of the resonator loaded with the material under test, thus disturbing the extracted permittivity. It has already been shown that spectral properties of these parasitic modes can be predicted using a recently developed electromagnetic model of a FPOR based on the scattering matrix method. It is shown in this article that the systematic analysis of experimental results supplemented with accurate numerical computations allows us to suppress the impact of mode coupling on the measured permittivity.
19 August 2020 in IEEE Transactions on Antennas and Propagation
New functionalities of the ray tracing method applicable in the modeling of radiowave propagation in the atmosphere are presented in this paper. First of all, wide angle approximation is applied to derive the ray tracing algorithm having no limitations imposed on the elevation angle above the ground. Secondly, it is proposed to use intensity law known in geometrical optics to account precisely for the complex amplitude along the propagating beam. Consequently, the method can be used to consider rigorously such phenomena as interference, diffraction and scattering of the wave. Eventually, it is also proposed how to account for the scattering of the beam on a target with known angular characteristic of a radar cross-section located on a radar scene. All these novel features of the ray-tracing method make it useful in the analysis of a target positioning error due to atmospheric conditions, which is also presented in this paper in comparison to other techniques.
6 September 2023 in IEEE Transactions on Microwave Theory and Techniques
Advancements in the automation and numerical modeling of a Fabry–Perot open resonator (FPOR) have made it a very convenient technological platform for various applications related to the microwave characterization of materials, including dielectric sheets and conductors. In this article, it is proposed how to use this kind of resonator in the characterization of low-loss liquids, which has recently become of high interest, especially coolants due to their increasing role in the so-called full immersion liquid cooling of big data centers. First, a new rigorous electromagnetic (EM) model of the FPOR loaded with a multilayer structure is proposed and validated. Next, a dedicated liquid container, which allows well controlling the thickness of the liquid under test (LUT), is presented. Eventually, several experiments are performed at room temperature with a few types of liquids, such as fluoroinert, canola oil, and engine oil, and compared against alternative resonant measurement methods to validate the proposed measurement concept and show its unique properties.