The European Alps, the cradle of pioneering glacial studies, are one of the regions where geological markers of past glaciations are most abundant and well-studied. Such conditions make the region ideal for testing numerical glacier models based on simplified ice flow physics against field-based reconstructions and vice versa. Here, we use the Parallel Ice Sheet Model (PISM) to model the entire last glacial cycle (120–0 ka) in the Alps, using horizontal resolutions of 2 and 1 km. Climate forcing is derived using two sources: present-day climate data from WorldClim and the ERA-Interim reanalysis; time-dependent temperature offsets from multiple palaeo-climate proxies. Among the latter, only the European Project for Ice Coring in Antarctica (EPICA) ice core record yields glaciation during marine oxygen isotope stages 4 (69–62 ka) and 2 (34–18 ka). This is spatially and temporally consistent with the geological reconstructions, while the other records used result in excessive early glacial cycle ice cover and a late Last Glacial Maximum. Despite the low variability of this Antarctic-based climate forcing, our simulation depicts a highly dynamic ice sheet, showing that Alpine glaciers may have advanced many times over the foreland during the last glacial cycle. Ice flow patterns during peak glaciation are largely governed by subglacial topography but include occasional transfluences through the mountain passes. Modelled maximum ice surface is on average 861 m higher than observed trimline elevations in the upper Rhône Valley, yet our simulation predicts little erosion at high elevation due to cold-based ice. Finally, despite the uniform climate forcing, differencesin glacier catchment hypsometry produce a time-transgressive Last Glacial Maximum advance, with some glaciers reaching their modelled maximum extent as early as 27 ka and others as late as 21 ka.

The Quaternary filling of the Upper Rhine Graben is an excellent archive to reconstruct sediment dynamics in response to climate change, in particular related to past glaciations of the Swiss Alpine Foreland. Here, a sediment sequence recovered by drilling for exploration purposes near Kronau is investigated, using a combination of sedimentological logging, provenance studies (heavy minerals and clast petrography), and luminescence dating. Several phases of coarse sediment aggradation are identified that possibly correlate to Marine Isotope Stages (MIS) 12 (478–424 ka), 10 (374–337 ka), 8 (300–243 ka), 6 (191–130 ka) and/or 4 (71–57 ka), and 2 (29–14 ka). Several of these phases have previously also been reported from cores recovered in the major Quaternary depo-centre near Heidelberg. This suggests that the observed coarse aggradation in the Upper Rhine Graben can be assigned to various glaciations in northern Switzerland: Möhlin (MIS 12), Habsburg (MIS 10 or 8), Beringen (MIS 6), an unnamed glacial advance during MIS 4, and Birrfeld (MIS 2). However, due to the limited data available, this hypothesis and the suggested correlations require further confirmation by applying the approach presented here to further cores from the Upper Rhine Graben.

While the history of a fluvial hydrosystem can provide essential knowledge on present functioning, historical context remains rarely considered in river restoration. Here we show the relevance of an interdisciplinary study for improving restoration within the framework of a European LIFE+ project on the French side of the Upper Rhine (Rohrschollen Island). Investigating the planimetric evolution combined with historical high-flow data enabled us to reconstruct pre-disturbance hydromorphological functioning and major changes that occurred on the reach. A deposition frequency assessment combining vertical evolution of the Rhine thalweg, chronology of deposits in the floodplain, and a hydrological model revealed that the period of incision in the main channel corresponded to high rates of narrowing and lateral channel filling. Analysis of filling processes using Passega diagrams and IRSL dating highlights that periods of engineering works were closely related to fine sediment deposition, which also presents concomitant heavy metal accumulation. In fact, current fluvial forms, processes and sediment chemistry around Rohrschollen Island directly reflect the disturbances that occurred during past correction works, and up to today. Our results underscore the advantage of combining functional restoration with detailed knowledge of the past trajectory to (i) understand the functioning of the hydrosystem prior to anthropogenic disturbances, (ii) characterize the human-driven morphodynamic adjustments during the last 2 centuries, (iii) characterize physico-chemical sediment properties to trace anthropogenic activities and evaluate the potential impact of the restoration on pollutant remobilization, (iv) deduce the post-restoration evolution tendency and (v) evaluate the efficiency and sustainability of the restoration effects. We anticipate our approach will expand the toolbox of decision-makers and help orientate functional restoration actions in the future.

Laser diffraction spectrometry allows for efficiently obtaining high-resolution grain size data. However, pretreatment and dispersion of aggregates in sediment samples are essential pre-requisites for acquiring accurate results using this method. This study evaluates the effectiveness of five dispersing agents in deflocculating the investigated fluvial sediments and the resulting grain size distribution obtained by laser diffraction spectrometry. We also examine the ability of the different dispersing agents to deflocculate sediment samples treated by thermal combustion. Distilled water presented a low efficiency in deflocculating the samples and yielded a near-zero clay content for samples with an expected clay content. The other chemical dispersants were effective in dispersing aggregates and yielding clay, albeit with different efficiencies. Calgon had the highest dispersing ability, followed closely by sodium tripolyphosphate. The performance of chemical treatment with sodium oxalate approaches that of sodium tripolyphosphate. However, it leads to the formation of precipitates in the samples, obscuring the actual grain size data. Sodium pyrophosphate derived the least amount of deflocculation among the four chemical dispersants. Furthermore, all the chemical dispersants were found to be ineffective in dispersing aggregates in samples treated by thermal combustion.

Deposits of the Reuss Glacier in the central northern Alpine foreland of Switzerland are dated using luminescence methodology. Methodological considerations on partial bleaching and fading correction of different signals imply the robustness of the results. An age of ca. 25 ka for sediment directly overlying basal lodgement till corresponds well with existing age constraints for the last maximal position of glaciers of the northern Swiss Alpine Foreland. Luminescence ages imply an earlier advance of Reuss Glacier into the lowlands during Marine Isotope Stage 4. The presented data are compared to findings from other parts of the Alps regarding glacier dynamics and palaeoclimatological implications, such as the source of precipitation during the Late Pleistocene.

The sedimentary infill of glacially overdeepened valleys (i.e., structures eroded below the fluvial base level) is an excellent but yet underexplored archive with regard to the age, extent, and nature of past glaciations. The ICDP project DOVE (Drilling Overdeepened Alpine Valleys) Phase 1 investigates a series of drill cores from glacially overdeepened troughs at several locations along the northern front of the Alps. All sites will be investigated with regard to several aspects of environmental dynamics during the Quaternary, with focus on the glaciation, vegetation, and landscape history. Geophysical methods (e.g., seismic surveys), for example, will explore the geometry of overdeepened structures to better understand the process of overdeepening. Sedimentological analyses combined with downhole logging, analysis of biological remains, and state-of-the-art geochronological methods, will enable us to reconstruct the erosion and sedimentation history of the overdeepened troughs. This approach is expected to yield significant novel data quantifying the extent and timing of Middle and Late Pleistocene glaciations of the Alps. In a first phase, two sites were drilled in late 2021 into filled overdeepenings below the paleolobe of the Rhine Glacier, and both recovered a trough filling composed of multiphase glacial sequences. Fully cored Hole 5068_1_C reached a depth of 165 m and recovered 10 m molasse bedrock at the base. This hole will be used together with two flush holes (5068_1_A, 5068_1_B) for further geophysical cross-well experiments. Site 5068_2 reached a depth of 255 m and bottomed out near the soft rock–bedrock contact. These two sites are complemented by three legacy drill sites that previously recovered filled overdeepenings below the more eastern Alpine Isar-Loisach, Salzach, and Traun paleoglacier lobes (5068_3, 5068_4, 5068_5). All analysis and interpretations of this DOVE Phase 1 will eventually lay the ground for an upcoming Phase 2 that will complete the pan-Alpine approach. This follow-up phase will investigate overdeepenings formerly occupied by paleoglacier lobes from the western and southern Alpine margins through drilling sites in France, Italy, and Slovenia. Available geological information and infrastructure make the Alps an ideal area to study overdeepened structures; however, the expected results of this study will not be restricted to the Alps. Such features are also known from other formerly glaciated mountain ranges, which are less studied than the Alps and more problematic with regards to drilling logistics. The results of this study will serve as textbook concepts to understand a full range of geological processes relevant to formerly glaciated areas all over our planet.